Knife Slitting Machine

Knife Slitting Machine

Slitting machine instruction manual -

Second, the use of procedures;

5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.

Knife Slitting Machine

Slitting machine operating procedures -

Third, through the film:

13. After all the paper cores on both sides are glued, press “Crop 1 Clamp” and “Reel 2 Clamp” at the same time, and then press “Rewind side 1 open” and “winding side 2 open” at the same time. The position is automatically swung until the winding paper core is pressed against the upper roller, the winding main body is started, and the film is slowly wound until it is tight. (The two-button white indicator light turns from blinking to steady light)

Knife Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

 

six. Burr

The raw edge product not only affects the appearance, but also directly affects the use. The edging product is observed with a magnifying glass. The edge of the film is jagged. The film roll is prone to breakage during use, and the consequences are very serious. For example, if the printed film breaks during the printing process, the ink will be caused. Splash, need to clean the machine and the ground, and then lead the film, re-coloring and other processes, production of physical and working loss; if the tape film breaks during the coating process, it is necessary to open the oven more than ten meters, re-introduction Membrane, turn off the oven, heat up and reproduce. These are things that users are very annoying and we must pay attention to.

In addition, we must pay attention to the protection of the end face during the moving process of the film roll, the film end face gap caused by the operation accident, and the gap has high concealment, the problem is difficult to find and flow to the user, the product will be Use has a greater impact.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com