High Quality Adhesive Tape Slitting Machine

High Quality Adhesive Tape Slitting Machine

Slitting machine instruction manual -

Second, the use of procedures;

5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.

High Quality Adhesive Tape Slitting Machine

Slitting machine operating procedures -

Third, through the film:

14. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.
15. If necessary, perform parent roll adjustment, brake tension adjustment, and flattening roller position check at low speed.

High Quality Adhesive Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Seven. Sharp edge
The curling occurs at the edge of the film winding, which causes the curling. The reason is that the edge of the thick film is curled up and the edge part is lifted up; the second is that the winding is too tight, and the tension can be shortened by slitting. Speed ??to improve the resulting edge curling phenomenon; third, the cutter is too blunt, and the stretching phenomenon occurs at the slit when slitting, causing the edge of the film roll to be turned outwards after winding to cause the curling edge, and the cutting should be replaced in time. The knife can avoid the occurrence of the curling problem; the fourth is that the tool is not installed correctly, such as the blade is close to the edge of the sipe and the blade is passivated. Cutting with a round knife can improve the curling of the film roll.
In the use of the unwinding process, there will be different degrees of side-floating in the unwinding process, and it is impossible to track the alignment with the electric eye, which directly affects the use effect. Therefore, it is necessary to change the product with the curled edge.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com