Air Knife Tape Slitting Machine

Air Knife Tape Slitting Machine

Slitting machine instruction manual -

Second, the use of procedures;

5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.

Air Knife Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)

2. Interface identifier
Due to the large thickness of the film interface, the film roll for some applications must be properly handled at the interface to avoid unnecessary problems, such as slowing down, increasing the gap between the coating blade, and printing the offset plate. The interface products must be identified as necessary to facilitate customer identification and internal management.
1 The color of the adhesive interface is generally beige, special requirements are used according to the regulations. For example, Shanghai Ziquan requires the use of black adhesive tape; the marking method of the joint position is operated according to the regulations, such as Zhuhai Zhongfu Pearl Film, Shenzhen Ruimei The hot film is required to be marked at the ends of the interface with yellow paper dust protruding from the end of the film roll by about 1 cm; other special marks are operated according to the requirements of the production tribe.
2 Require the slitting workshop to mark the length number of the joint product without special requirements after the length of the label in the length column of the package label, and mark the “buter” mark on the note bar of the computer, and mark “+” on the remark column. Marking, pearl film and imitation paper film and exporting pearl film should indicate the length of each product before and after the joint on the length column of the product specification. For special requirements, the relevant marking work should be done according to the regulations (such as Shanghai Ziquan product port). The rate of less than or greater than 25% requires the number of interface products on each board product).

Air Knife Tape Slitting Machine

The basic knowledge of the slitting machine and its development process --

Basic knowledge and development of slitting machine

In the process of slitting, the stable tension system is an important indicator to ensure the quality of the product. It controls the mutual tension between unwinding, drawing, slitting, winding, etc., so that the slitting material is always in the cutting process. A steady state. If the tension is properly controlled, it can avoid the deformation and drift of the raw materials during the process of speeding up and slowing down the machine. Generally, the unwinding tension is slightly larger than the sum of the reel tensions. Most of the previous slitting machines use magnetic powder clutch to control the tension, but the magnetic powder clutch speed can not be high. It is easy to cause high-speed friction of the magnetic powder during operation, which causes high temperature and shortens its life. In severe cases, it will be stuck and the machine operation will be blocked. With the development of science and technology, the use of servo drive technology, most of them now use vector variable frequency motor to control the tension system of the slitting machine. The automatic detection of the pendulum roller makes the man-machine interface intuitive, the tension system is more stable and reliable, and easy to operate.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com