Slitting machine instruction manual -
Second, the use of procedures;
6. The gears inside the tool holder are regularly cleaned and greased.
7. When moving the tool holder, remove the upper and lower screws and translate it to the left to release the blade from the blade groove of the drum. Then release the timing belt and pull out the timing pulley on the tool holder shaft to remove the whole. Tool holder for maintenance and cleaning.
During installation, the tool holder translates against the drum, so that the blade is correctly cut into the drum groove, fix the upper and lower screws, install the timing pulley from the back, and loosen the foot screw of the drive motor to the right to facilitate the synchronization. With the belt, then the motor base moves to the right, confirming the proper tightness of the timing belt, and fixing the motor base screw to work normally.
Reasons, countermeasures and effects of BOPP film slitting quality ---
eleven. Width deviation is too large
The width of the film roll is limited by the gap of the sipe roll. The actual slit width will deviate from the width required for the order, but the deviation should be controlled within the tolerance range of ±2mm required by the national standard. The so-called width deviation Large, that is, the actual width of the film roll exceeds the requirements of internal control standards or customer standards.
Not all products have a tolerance of ±2mm, and some customers can only take deviations from the film width, such as the Pd film of Kunshan Zhangpu, the LL film of Shanghai Zhicheng, the PL film of Beijing Amcor, etc. It is required to adjust the film width.
Domestic cutting machine development status and outlets ---
1. Not rigorous in the manufacturing process
Tolerance control in the mechanical manufacturing process is not precise enough, and the surface is rough, especially in the matching electroplating industry, which is shoddy. There is a defect in the dynamic balance of the roller for cutting the Chinese-made equipment at one time. The lag of the related industry, the rubber coated by the roller has far less wear resistance and anti-aging than the foreign products. The bearings used seem to use well-known foreign brands, but the counterfeit and shoddy floods the domestic bearing market. Even when the real goods are purchased, the precision is far lower than the precision used by foreign slitting machines.
In the entire production process of a slitting machine, there is no guarantee of production process. At present, most of the slitting machines produced in China are completed by a number of outsourcing units, and the quality of their production is even more difficult to guarantee. In addition, the metal materials used and the heat treatment process are not rigorous enough, resulting in many problems in the use of a slitting machine. It has seriously affected the share of a slitting machine in the domestic market. The secondary and tertiary slitting machines have fewer problems than the one slitting machine, because the parts of the secondary and tertiary slitting machines are completed by the slitting machine manufacturer, and the dynamic balancing machine used is in a narrow range. It can accurately control the unbalanced grams, and the industrial difficulty coefficient of manufacturing is reduced. Its selling price is far lower than that of foreign products. Therefore, the proportion of domestically produced slitting machines in the domestic slitting machine market getting bigger.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc