Automatic Stationery Adhesive Tape Slitter Machine

Automatic Stationery Adhesive Tape Slitter Machine

Slitting machine instruction manual -

Second, the use of procedures;

6. The gears inside the tool holder are regularly cleaned and greased.
7. When moving the tool holder, remove the upper and lower screws and translate it to the left to release the blade from the blade groove of the drum. Then release the timing belt and pull out the timing pulley on the tool holder shaft to remove the whole. Tool holder for maintenance and cleaning.
During installation, the tool holder translates against the drum, so that the blade is correctly cut into the drum groove, fix the upper and lower screws, install the timing pulley from the back, and loosen the foot screw of the drive motor to the right to facilitate the synchronization. With the belt, then the motor base moves to the right, confirming the proper tightness of the timing belt, and fixing the motor base screw to work normally.

Automatic Stationery Adhesive Tape Slitter Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)

2. Interface identifier
Due to the large thickness of the film interface, the film roll for some applications must be properly handled at the interface to avoid unnecessary problems, such as slowing down, increasing the gap between the coating blade, and printing the offset plate. The interface products must be identified as necessary to facilitate customer identification and internal management.
1 The color of the adhesive interface is generally beige, special requirements are used according to the regulations. For example, Shanghai Ziquan requires the use of black adhesive tape; the marking method of the joint position is operated according to the regulations, such as Zhuhai Zhongfu Pearl Film, Shenzhen Ruimei The hot film is required to be marked at the ends of the interface with yellow paper dust protruding from the end of the film roll by about 1 cm; other special marks are operated according to the requirements of the production tribe.
2 Require the slitting workshop to mark the length number of the joint product without special requirements after the length of the label in the length column of the package label, and mark the “buter” mark on the note bar of the computer, and mark “+” on the remark column. Marking, pearl film and imitation paper film and exporting pearl film should indicate the length of each product before and after the joint on the length column of the product specification. For special requirements, the relevant marking work should be done according to the regulations (such as Shanghai Ziquan product port). The rate of less than or greater than 25% requires the number of interface products on each board product).

Automatic Stationery Adhesive Tape Slitter Machine

The basic knowledge of the slitting machine and its development process --

Basic knowledge and development of slitting machine

When it comes to the efficiency of the slitter, many people think that the efficiency of the slitter is only related to the speed of the slitter. Actually, I think that the efficiency of the slitter is related to the following factors: slitting speed, finished product. Rate, non-operation time, stability, etc. Although the cutting speed is an important indicator of the working efficiency of the slitting machine, if the yield is low, not only will the work efficiency of the whole machine be low, but also the cost will increase. Similarly, if the non-operation takes a long time, such as: adjusting the machine, setting the tool, changing the tool, refueling, connecting the joint, changing the volume, processing the problem, etc., it takes a long time to improve the speed of the slitter, and it makes no sense. It is. Not to mention the stability of the slitting machine, not only will it affect the working efficiency of the slitting machine, but also affect the quality of the product, and it will cause trouble and unnecessary waste to the next process. Therefore, the efficiency of the slitter is a comprehensive concept.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com