Aluminum Foil Slitting And Rewinding Machine

Aluminum Foil Slitting And Rewinding Machine

Slitting machine operating procedures -

First. When the unwinding machine normally replaces the parent roll
1. The machine is wound up and the machine speed is zero. Press the "machine off" button and all drives are turned off.
2. Press and hold the “core release” button to make the chuck exit the empty core, the empty core is placed on the unloading guide, and then the pneumatic ejector will automatically
Empty the core to the unloading position, release the button, and the steel core is to be transported away by the crane.
3. Press the “Coil Snap” button briefly to retract the cylinder rod at the unwinding position to the receiving position.
4. According to the plan, attach the corresponding mother roll to the double-sided tape, and hang the new mother roll into the V-shaped support that supports the parent roll, and hang the empty roll.
core.
5. Press and hold the “Coil Core Clamp” button to make the card head into the new parent roll until the card head positioning pin is in place and release the button. 6. Adjust the length and diameter of the unwinder on the operation screen (correct the input value if necessary), and replace the parent roll.

Aluminum Foil Slitting And Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)

3. Interface length and interface rate requirements
Since the interface products will inevitably generate certain scraps before and after the interface, and the quality of the interface products cannot reach 100% of the quality level of the interfaceless products, increasing the loss of use, therefore, the film manufacturers and users are The number of interfaces of the volume product and the interface ratio of each batch of products are specified, so that the interface products are controlled within a certain range.

Aluminum Foil Slitting And Rewinding Machine

The basic knowledge of the slitting machine and its development process --

Basic knowledge and development of slitting machine

When it comes to the efficiency of the slitter, many people think that the efficiency of the slitter is only related to the speed of the slitter. Actually, I think that the efficiency of the slitter is related to the following factors: slitting speed, finished product. Rate, non-operation time, stability, etc. Although the cutting speed is an important indicator of the working efficiency of the slitting machine, if the yield is low, not only will the work efficiency of the whole machine be low, but also the cost will increase. Similarly, if the non-operation takes a long time, such as: adjusting the machine, setting the tool, changing the tool, refueling, connecting the joint, changing the volume, processing the problem, etc., it takes a long time to improve the speed of the slitter, and it makes no sense. It is. Not to mention the stability of the slitting machine, not only will it affect the working efficiency of the slitting machine, but also affect the quality of the product, and it will cause trouble and unnecessary waste to the next process. Therefore, the efficiency of the slitter is a comprehensive concept.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com