Bopp Packing Tape Slitting Rewinding

Bopp Packing Tape Slitting Rewinding

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)
1. Press and hold the “winding side 1 swing” and “winding side 2 swing” buttons until the finished roll leaves the press roller (winding arm vertical state). 2. At the same time, the blades cut off the finished product on both sides, and the end of the film is glued to the finished roll as the end mark of the finished roll. 3. Continue to press and hold the “winding side 1 swing” and “winding side 2 swing” buttons, and the winding arm will open to both sides until the finished product rolls over to the unloading trolley tray and release the button.
4. Press the “Release side 1 card head release” and “Rewind side 2 card head release” buttons, the card head will open, release the finished product roll (if the finished product roll does not come down, manually shake the finished product roll).
5. Press and hold the “winding side 1 swinging” and “winding side 2 swinging” keys, and the winding arm station will be turned up and forward until the winding arm reaches the paper discharge core position and release the button.

6. Unload and unwind the trolley and advance the finished product to the packaging area.
7. After the winding arm is in the correct position, manually install the empty paper core (the double-sided adhesive should be attached to the paper core).

Bopp Packing Tape Slitting Rewinding

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)

3. Interface length and interface rate requirements
Since the interface products will inevitably generate certain scraps before and after the interface, and the quality of the interface products cannot reach 100% of the quality level of the interfaceless products, increasing the loss of use, therefore, the film manufacturers and users are The number of interfaces of the volume product and the interface ratio of each batch of products are specified, so that the interface products are controlled within a certain range.

Bopp Packing Tape Slitting Rewinding

The basic knowledge of the slitting machine and its development process --

Basic knowledge and development of slitting machine

In the process of slitting, the stable tension system is an important indicator to ensure the quality of the product. It controls the mutual tension between unwinding, drawing, slitting, winding, etc., so that the slitting material is always in the cutting process. A steady state. If the tension is properly controlled, it can avoid the deformation and drift of the raw materials during the process of speeding up and slowing down the machine. Generally, the unwinding tension is slightly larger than the sum of the reel tensions. Most of the previous slitting machines use magnetic powder clutch to control the tension, but the magnetic powder clutch speed can not be high. It is easy to cause high-speed friction of the magnetic powder during operation, which causes high temperature and shortens its life. In severe cases, it will be stuck and the machine operation will be blocked. With the development of science and technology, the use of servo drive technology, most of them now use vector variable frequency motor to control the tension system of the slitting machine. The automatic detection of the pendulum roller makes the man-machine interface intuitive, the tension system is more stable and reliable, and easy to operate.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com