China Bopp Packing Tape

China Bopp Packing Tape

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)

8. Operate the button on the winding arm to wind up the paper core.
9. Manually cut the film to be cut onto the corresponding rewinding paper core. After tightening the film, it is firmly adhered to the paper core (note that the side 1 and side 2 films are differently worn).
10. After all the paper cores on both sides are glued, press “Crop 1 Clamp” and “Reel 2 Clamp” at the same time, and then press “Rewind side 1 open” and “winding side 2 open” at the same time. The position is automatically swung until the winding paper core is pressed against the upper roller, the winding main body is started, and the film is slowly wound until it is tight. (The two-button white indicator light turns from blinking to steady light)
11. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.

12. The main operator shall check the winding condition of each film and fine-tune the winding arm if necessary.

China Bopp Packing Tape

Slitting machine operating procedures -

Third, through the film:

14. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.
15. If necessary, perform parent roll adjustment, brake tension adjustment, and flattening roller position check at low speed.

China Bopp Packing Tape

Reasons, countermeasures and effects of BOPP film slitting quality ---

ten. Color circle
The color circle is caused by a certain degree of contamination inside or outside the film, which causes the quality of the color circle on the end face of the film roll after slitting and winding. Membrane surface pollution sources come from two aspects. One is the film-forming process. The color circles generated in the front part of the film, such as raw materials, feeding systems, extrusion systems, and die flow channels, generally cause pollution to the inside of the film (core layer). Some color-circle products can clearly observe a large amount of fish-eye impurities in the film. The color circles generated in the film-forming stage and the slitting process mainly cause pollution to the outside (surface) of the film, but whether it is internal or external pollution, It is impossible to remove the impurities from the contaminated film and restore the original appearance. The product with serious color circle has low transparency, the film color is different from the normal product, and it can not be used at all. It can only be reduced to other external treatments, while the products with slight color circles are It has little effect on the transparency of the product and does not affect the use effect of the single film. However, due to the inconspicuous appearance of the color circle product, the “selling phase” is poor, which has a great influence on the image of the German brand. It is not suitable for direct delivery. Secondary processing. If the color circle is caused by external dust pollution factors, the dust will be adsorbed on the surface of the film, resulting in poor quality of heat sealing and poor laser compression.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com