High Speed Bopp Adhesive Tape Slitting Machine

High Speed Bopp Adhesive Tape Slitting Machine

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)

8. Operate the button on the winding arm to wind up the paper core.
9. Manually cut the film to be cut onto the corresponding rewinding paper core. After tightening the film, it is firmly adhered to the paper core (note that the side 1 and side 2 films are differently worn).
10. After all the paper cores on both sides are glued, press “Crop 1 Clamp” and “Reel 2 Clamp” at the same time, and then press “Rewind side 1 open” and “winding side 2 open” at the same time. The position is automatically swung until the winding paper core is pressed against the upper roller, the winding main body is started, and the film is slowly wound until it is tight. (The two-button white indicator light turns from blinking to steady light)
11. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.

12. The main operator shall check the winding condition of each film and fine-tune the winding arm if necessary.

High Speed Bopp Adhesive Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)
1. Interface requirements
Due to poor interface, the quality of the film roll may be broken or wrinkled, which may cause adverse effects in the user's use. Therefore, the film interface must be connected to the specified specification to ensure the joint quality of the interface. Specific requirements are as follows: 
1 The two sections of the joint are cut and flattened horizontally, and the beige (or other specified color) adhesive tape with a width of 72 mm is firmly adhered to the front and back sides of the film;
2 In order to improve the interface quality, the film interface is required to be straight and balanced with the paper tube direction, and the interface is required to be flush and wavy. The interfaces at both ends are in the middle of the tape. Try to avoid the size of the edge. The adhesive tape is attached to the film. No obvious bubbles;
3 The film surface at the interface is required to be smooth without obvious wrinkling;
4 Do the identification of the joint position as specified.

High Speed Bopp Adhesive Tape Slitting Machine

Domestic cutting machine development status and outlets ---

2. Lack of composite professional talents who understand manufacturing technology and process and know cutting process
In the manufacturing process of the slitting machine, different customers are often faced with different materials and requirements. If different manufacturers produce the same materials, the raw materials used are not the same chemical plant products, and the physical properties of the materials produced are not the same. When producing the slitting machine, it cannot be generalized. In the production process, the manufacturing process will change, especially in the size of the roll diameter and the thickness of the coating layer, the difference between the active roller and the passive roller and the wrap angle of the roller surface, etc. The lack of corresponding research talents in the field often leads to many waste products and defective products in the slitting process. Such composite talents should not only be familiar with the design and manufacturing process of the entire slitting machine, but also understand the different characteristics of different materials during slitting. Currently, it is very scarce in China, which leads to the current situation of domestic slitting machines.
 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com