Stationery Adhesive Tape Slitter Machine

Stationery Adhesive Tape Slitter Machine

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)

8. Operate the button on the winding arm to wind up the paper core.
9. Manually cut the film to be cut onto the corresponding rewinding paper core. After tightening the film, it is firmly adhered to the paper core (note that the side 1 and side 2 films are differently worn).
10. After all the paper cores on both sides are glued, press “Crop 1 Clamp” and “Reel 2 Clamp” at the same time, and then press “Rewind side 1 open” and “winding side 2 open” at the same time. The position is automatically swung until the winding paper core is pressed against the upper roller, the winding main body is started, and the film is slowly wound until it is tight. (The two-button white indicator light turns from blinking to steady light)
11. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.

12. The main operator shall check the winding condition of each film and fine-tune the winding arm if necessary.

Stationery Adhesive Tape Slitter Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

 

It should be noted that although the quality index of the film has a tolerance upper and lower limit, such as 10m wrinkle, film width ± 2mm, end face irregularity ≤ 1 mm, etc., tolerance is the limit of product quality acceptance, but Does not mean that our products can be continuous or close to the upper and lower limits of the tolerance during the slitting process. When we find that the product is at or near the upper and lower limits of the quality tolerance, the production operation or equipment must have an abnormal situation, we must Take immediate measures to correct, eliminate the influencing factors, and ensure the continuous stability and improvement of product quality.

Stationery Adhesive Tape Slitter Machine

The basic knowledge of the slitting machine and its development process --

Basic knowledge and development of slitting machine

In the process of slitting, the stable tension system is an important indicator to ensure the quality of the product. It controls the mutual tension between unwinding, drawing, slitting, winding, etc., so that the slitting material is always in the cutting process. A steady state. If the tension is properly controlled, it can avoid the deformation and drift of the raw materials during the process of speeding up and slowing down the machine. Generally, the unwinding tension is slightly larger than the sum of the reel tensions. Most of the previous slitting machines use magnetic powder clutch to control the tension, but the magnetic powder clutch speed can not be high. It is easy to cause high-speed friction of the magnetic powder during operation, which causes high temperature and shortens its life. In severe cases, it will be stuck and the machine operation will be blocked. With the development of science and technology, the use of servo drive technology, most of them now use vector variable frequency motor to control the tension system of the slitting machine. The automatic detection of the pendulum roller makes the man-machine interface intuitive, the tension system is more stable and reliable, and easy to operate.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com