Slitting machine operating procedures -
Second, the volume of the replacement of the finished product (operating station)
8. Operate the button on the winding arm to wind up the paper core.
9. Manually cut the film to be cut onto the corresponding rewinding paper core. After tightening the film, it is firmly adhered to the paper core (note that the side 1 and side 2 films are differently worn).
10. After all the paper cores on both sides are glued, press “Crop 1 Clamp” and “Reel 2 Clamp” at the same time, and then press “Rewind side 1 open” and “winding side 2 open” at the same time. The position is automatically swung until the winding paper core is pressed against the upper roller, the winding main body is started, and the film is slowly wound until it is tight. (The two-button white indicator light turns from blinking to steady light)
11. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.
12. The main operator shall check the winding condition of each film and fine-tune the winding arm if necessary.
Slip axis and air shaft of slitting machine--
1: Inflatable operation time is short, the separation and placement of the inflation shaft and the paper tube can be completed in 3 seconds to complete the inflation and deflation, and it is not necessary to separate any parts on the shaft end side to be tightly engaged with the paper tube.
2: The paper tube is simply placed: in the action of inflation and deflation, the paper tube can be moved and fixed at any position on the shaft surface.
3: The bearing weight is large: the diameter of the shaft can be determined according to the actual needs of the customer, and the high-hardness steel is used to make the bearing weight increase.
4: High economic efficiency: The design of the shaft is special, and it can be applied to all kinds of paper tubes of thick, thin, wide and narrow.
5: Simple maintenance and long use time: The inflation shaft is a single part, and each part in the structure has fixed specifications, which can be used interchangeably, making it easy to maintain.
Specifications: There are a variety of, including 1 inch, 1.5 inch, 2 inch, 2.5 inch, 3 inch, 6 inch, 8 inch, 10 inch, 12 inch, etc., according to demand can be processed to produce different specifications of the expansion axis.
Slitting machine operation guide ---
7 Equipment maintenance
7.1 Daily Insurance Project:
A The main part (including safety protection) should be inspected before work (shift or interruption).
B Press the lubrication diagram of the machine and refuel before working.
C A cleaning job should be performed and the tools should be placed in place before the end of each shift.
7.2 The contents of the weekly insurance shall be implemented in accordance with the relevant provisions of the “Device Two Guarantee Record”.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc