Core Loader Slitting And Rewinding Machine

Core Loader Slitting And Rewinding Machine

Slitting machine operating procedures -

Third, through the film:

14. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.
15. If necessary, perform parent roll adjustment, brake tension adjustment, and flattening roller position check at low speed.

Core Loader Slitting And Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)
1. Interface requirements
Due to poor interface, the quality of the film roll may be broken or wrinkled, which may cause adverse effects in the user's use. Therefore, the film interface must be connected to the specified specification to ensure the joint quality of the interface. Specific requirements are as follows: 
1 The two sections of the joint are cut and flattened horizontally, and the beige (or other specified color) adhesive tape with a width of 72 mm is firmly adhered to the front and back sides of the film;
2 In order to improve the interface quality, the film interface is required to be straight and balanced with the paper tube direction, and the interface is required to be flush and wavy. The interfaces at both ends are in the middle of the tape. Try to avoid the size of the edge. The adhesive tape is attached to the film. No obvious bubbles;
3 The film surface at the interface is required to be smooth without obvious wrinkling;
4 Do the identification of the joint position as specified.

Core Loader Slitting And Rewinding Machine

Domestic cutting machine development status and outlets ---

three. Domestic slitting machine development direction
The development direction of domestic slitting machines should be considered from three aspects:

2. Automation control part: At present, the automation level of the slitting machine produced in China is still at the middle and lower level. Although the domestic control of the original device has been widely used and the price is lower, the domestic slitter manufacturers are far away in use. It lags behind the level of developed countries, especially in the control system, and the lack of organic combination with the structure of the slitting machine and the material to be cut. At this level, most of the domestic slitting machines still stay on the thick lines. The rigor and rationality of the cutting machine control system has not been fully understood. I personally think that the domestic slitting machine manufacturers should start from the above several directions, and find out the method that meets the cutting and cutting principle of the slitting machine and can maximize the use of the functions provided by the hardware.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com