Slitting machine operating procedures -
Third, through the film：
14. Press the “MACHINE” button, the siren will sound and the signal light will flash yellow. Confirm that the personnel are in the safe area, press "machine on" again, the button light is always on, the machine starts and accelerates to the input set speed.
15. If necessary, perform parent roll adjustment, brake tension adjustment, and flattening roller position check at low speed.
Reasons, countermeasures and effects of BOPP film slitting quality ---
It should be noted that although the quality index of the film has a tolerance upper and lower limit, such as 10m wrinkle, film width ± 2mm, end face irregularity ≤ 1 mm, etc., tolerance is the limit of product quality acceptance, but Does not mean that our products can be continuous or close to the upper and lower limits of the tolerance during the slitting process. When we find that the product is at or near the upper and lower limits of the quality tolerance, the production operation or equipment must have an abnormal situation, we must Take immediate measures to correct, eliminate the influencing factors, and ensure the continuous stability and improvement of product quality.
Slitting machine parts ---
2. Attenuation and tension compensation of the tension of the rewinding and unwinding: It is generally believed that maintaining the constant tension of the aluminum foil during the rewinding and unwinding of the aluminum foil is beneficial to the apparent quality of the finished aluminum foil, but it is not. The best method is to increase the tension of the aluminum foil according to a certain rule as the diameter of the coil increases, and the smaller the diameter, the lower the tension value. There are automatic tension control and manual tension control during the slitting operation. The automatic tension control system is the leading set tension attenuation value, which is maintained throughout the winding process. The manual tension control requires the operator to continuously adjust the diameter of the master roll to meet the tension required for the aluminum foil during operation. When setting the automatic tension operation, set the initial tension before setting the tension attenuation value. Taking the setting of the slitting and unwinding attenuation value as an example, the setting principle is that the aluminum foil tension attenuation value (%) is equal to the tension at the end of winding of the aluminum foil minus the initial tension and then divided by the initial tension. Multiply by 100%. When setting the automatic tension value of the unwinding, it should not be too large, otherwise the aluminum foil winding surface has a large hardness and is prone to warping. But the tension should not be too small, too small and easy to cause the rewinding body to be too loose, and the winding is not neatly running. Therefore, the quality of the rewinding and unwinding during the aluminum foil slitting operation is mainly affected by the change of the tension of the aluminum foil. It can be seen that the mastery of the retracting and unwinding control system is the key to affecting the quality.
3. The change of speed during slitting affects the change of tension: When the speed is increased or decelerated, the speed of the main motor changes. Firstly, it causes the instantaneous change of the tension of the unwinding traction to the winding section of the aluminum foil, and it is necessary to slightly vibrate the aluminum foil after a period of time to gradually stabilize the tension. The instability of this tension is manifested in the fact that the finished roll is not well-wound, and the end face has unevenness, which affects the quality of the product.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc