Causes, countermeasures and effects on the quality of BOPP film slitting quality ---
(2) The purpose, method and characteristics of hardness testing
3. Method for detecting film roll hardness
1 selection of testing equipment
There are various instruments for detecting the hardness of an object, but so far there has not been a hardness tester that professionally detects the hardness of a film roll. Due to the large difference in surface hardness between various objects and the variety of hardness testers, it is important to select a hardness tester that can effectively reflect the tightness of the film roll. After screening and comparison, our company has determined the "A-type rubber hardness tester" for detecting the surface hardness of rubber products as an auxiliary instrument for detecting the tightness of the film roll.
2 detection instrument correction
Since the "A type rubber hardness tester" is not a special test instrument for the film roll, in order to improve the detection accuracy of the instrument, we have modified the structure of the hardness tester according to the characteristics of the film, and increased the presser area by 5 times.
3 detection methods a.
Before the test, the pointer of the hardness tester should be in the free state and point to the zero position. When pressing the hardness tester on the glass plate, the pointer should be 100 degrees (the end face of the press pin and the bottom of the foot are in close contact with the glass). If the zero position and the 100 degree are not indicated, the needle can be pressed slightly several times, if not When referring to zero and 100 degrees, it cannot be used. The hardness tester to be confirmed can be used again if it meets the requirements for use. b.
When testing the hardness, put the hardness tester on the side of the film product, take the left, middle and right positions, at least 40mm from the edge of the film roll, and firmly press the end of the hardness tester with both hands, so that the pressure pin is pressed vertically. The sample is read within 1 s until the pressure is fully contacted with the sample, and the average is taken and recorded.
Reasons, countermeasures and effects of BOPP film slitting quality ---
It should be noted that although the quality index of the film has a tolerance upper and lower limit, such as 10m wrinkle, film width ± 2mm, end face irregularity ≤ 1 mm, etc., tolerance is the limit of product quality acceptance, but Does not mean that our products can be continuous or close to the upper and lower limits of the tolerance during the slitting process. When we find that the product is at or near the upper and lower limits of the quality tolerance, the production operation or equipment must have an abnormal situation, we must Take immediate measures to correct, eliminate the influencing factors, and ensure the continuous stability and improvement of product quality.
Domestic cutting machine development status and outlets ---
three. Domestic slitting machine development direction
The development direction of domestic slitting machines should be considered from three aspects:
2. Automation control part: At present, the automation level of the slitting machine produced in China is still at the middle and lower level. Although the domestic control of the original device has been widely used and the price is lower, the domestic slitter manufacturers are far away in use. It lags behind the level of developed countries, especially in the control system, and the lack of organic combination with the structure of the slitting machine and the material to be cut. At this level, most of the domestic slitting machines still stay on the thick lines. The rigor and rationality of the cutting machine control system has not been fully understood. I personally think that the domestic slitting machine manufacturers should start from the above several directions, and find out the method that meets the cutting and cutting principle of the slitting machine and can maximize the use of the functions provided by the hardware.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc