Automatic Mattress Tape Edge Machine

Automatic Mattress Tape Edge Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

four. Deviation
Deviation refers to the phenomenon that part of the film on the end face of the film roll is misaligned, which is caused by the sliding of the film during the winding process.

1. The effect of deviation on usage
The effect of deviation on the use is basically the same as that of the end face, which is mainly to track the problem of alignment and the influence on the appearance of the product. Because the degree of misalignment of the deviation is much more obvious than that of the end face, it does not meet the requirements of the customer. Therefore, it must be processed twice, and it can be graded and packed into the warehouse after meeting the requirements.

Automatic Mattress Tape Edge Machine

Slitting machine operation guide ---

4.3 Tool change operation procedures
4.3.1 The tool change department is responsible for the tool change operation of the aluminum foil paper slitting machine and the cardboard paper slitting machine.
4.3.2 The tool change operation of the tipping paper slitting machine shall be carried out by the on-duty machine personnel according to the quality requirements under the guidance of the machine repair.
 

Automatic Mattress Tape Edge Machine

Slitting machine parts ---

1. Type of inspection system for the tension and speed of the slitting machine:
1 Tension sensor detection: The tension sensor is installed under the bearing of the tension detecting roller, converts the detected aluminum foil tension into an electrical signal, sends it to the tension adjuster, compares it with the original set tension signal, performs PID calculation, and then inputs The winding motor controller achieves the purpose of controlling the tension and rotation speed of the winding roller.
2Floating roller indirect tension detecting system: a set of floating roller is installed in front of the aluminum foil tracking roller. The position of the floating roller is detected by a potentiometer. The tension control method is to keep the tension constant by keeping the position of the floating roller as constant as possible. .
3 The magnetic powder clutch is used to control the rotational torque of the input winding roller to achieve tension control: the magnetic powder clutch is composed of an active part and a driven part, and is connected to the winding roller through a transmission mechanism such as a universal joint, and the fine ferromagnetic powder is filled in the middle. As a torque transmission medium. A magnetic field is formed by applying a constant current to the exciting coil, and the magnetic powder is magnetized. The magnetized magnetic powder attracts each other to form a chain arrangement. When the active part rotates at a constant speed, the coupling force between the magnetic powders is broken to form a circumferential tangential force, and the product of the tangential force and the radius of the magnetic ring is the driving driven part. The winding torque of the winding realizes the coupling of the output torque from the active part to the driven part in continuous rotation, thereby achieving the purpose of controlling the tension.
4 slitting Unwinding capacity and speed detection system: The magnetic powder tension brake is mainly used to control the unwinding force and speed. The working principle is: the coupling is installed in the magnetic powder brake, and the input parts and output with magnetic coils are installed. component. Below the magnetic coil is an annular groove, the underside of which is an annular rotor or output member. The annular groove is located at the center of the output member and is filled with magnetic powder. When there is excitation current in the magnetic coil, the coil generates magnetic flux to align the magnetic powder in the direction of the magnetic field, thus generating damping between the input member and the output member, and transmitting the torque. If the tension and speed applied to the aluminum foil are increased or decreased, the magnitude of the exciting current can be changed, or the magnitude of the current applied to the coupling coil by the varying amplifier can be effectively controlled.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com