Adhesive Tape Shrink Packaging Machine

Adhesive Tape Shrink Packaging Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Fives. Multilateral
Although the polygon and the end face are not the same as the faulty end faces of some layers of the film roll, the two are different. The unevenness of the end face is the jagged phenomenon that occurs when the film width is not changed, and the multilateral product The film width is slightly wider than the normal size.

1. Multilateral impact on quality of use
The impact of multilateral use on the end is basically the same as that of the end face, mainly to track the problem of alignment and the impact on the appearance of the product.



Adhesive Tape Shrink Packaging Machine

Slitting machine operation guide ---

8.1 The cutting personnel shall record the production status in the “production record of the cutting machine” and other related records, insert the product into the “product tracking card”, and fill in the corresponding content in time according to the column and frequency requirements set in the record. The disk customers fill in the theoretical weight of each product for the weight of the product label of the Xiamen Cigarette Factory (see the attached table for the theoretical weight of each product), and the content is complete, clear, true and accurate.
8.2 Records should not be filled in with a pencil. The record holder should sign the quality record and indicate the time the record was filled.
8.3 The records listed in the record (except the remarks column) should be filled in. If the corresponding content is not found or there is no item, it can be recorded by slashing. The operator should write the full name and must not only write the last name.
8.4 Record changes caused by mistakes, etc. shall not exceed three pages per page. The records shall be clearly identifiable after the change. For all kinds of quality records that are validated and validated by the product and system, the change shall be stamped with a proofreading or marked change. people.

Adhesive Tape Shrink Packaging Machine

Domestic cutting machine development status and outlets ---

three. Domestic slitting machine development direction
The development direction of domestic slitting machines should be considered from three aspects:

2. Automation control part: At present, the automation level of the slitting machine produced in China is still at the middle and lower level. Although the domestic control of the original device has been widely used and the price is lower, the domestic slitter manufacturers are far away in use. It lags behind the level of developed countries, especially in the control system, and the lack of organic combination with the structure of the slitting machine and the material to be cut. At this level, most of the domestic slitting machines still stay on the thick lines. The rigor and rationality of the cutting machine control system has not been fully understood. I personally think that the domestic slitting machine manufacturers should start from the above several directions, and find out the method that meets the cutting and cutting principle of the slitting machine and can maximize the use of the functions provided by the hardware.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?