Aluminum Foil Tape 600 Mph Tape

Aluminum Foil Tape 600 Mph Tape

Reasons, countermeasures and effects of BOPP film slitting quality ---

ten. Color circle
The color circle is caused by a certain degree of contamination inside or outside the film, which causes the quality of the color circle on the end face of the film roll after slitting and winding. Membrane surface pollution sources come from two aspects. One is the film-forming process. The color circles generated in the front part of the film, such as raw materials, feeding systems, extrusion systems, and die flow channels, generally cause pollution to the inside of the film (core layer). Some color-circle products can clearly observe a large amount of fish-eye impurities in the film. The color circles generated in the film-forming stage and the slitting process mainly cause pollution to the outside (surface) of the film, but whether it is internal or external pollution, It is impossible to remove the impurities from the contaminated film and restore the original appearance. The product with serious color circle has low transparency, the film color is different from the normal product, and it can not be used at all. It can only be reduced to other external treatments, while the products with slight color circles are It has little effect on the transparency of the product and does not affect the use effect of the single film. However, due to the inconspicuous appearance of the color circle product, the “selling phase” is poor, which has a great influence on the image of the German brand. It is not suitable for direct delivery. Secondary processing. If the color circle is caused by external dust pollution factors, the dust will be adsorbed on the surface of the film, resulting in poor quality of heat sealing and poor laser compression.

Aluminum Foil Tape 600 Mph Tape

Domestic cutting machine development status and outlets ---

2. Lack of composite professional talents who understand manufacturing technology and process and know cutting process
In the manufacturing process of the slitting machine, different customers are often faced with different materials and requirements. If different manufacturers produce the same materials, the raw materials used are not the same chemical plant products, and the physical properties of the materials produced are not the same. When producing the slitting machine, it cannot be generalized. In the production process, the manufacturing process will change, especially in the size of the roll diameter and the thickness of the coating layer, the difference between the active roller and the passive roller and the wrap angle of the roller surface, etc. The lack of corresponding research talents in the field often leads to many waste products and defective products in the slitting process. Such composite talents should not only be familiar with the design and manufacturing process of the entire slitting machine, but also understand the different characteristics of different materials during slitting. Currently, it is very scarce in China, which leads to the current situation of domestic slitting machines.
 

Aluminum Foil Tape 600 Mph Tape

Domestic cutting machine development status and outlets ---

three. Domestic slitting machine development direction
The development direction of domestic slitting machines should be considered from three aspects:

2. Automation control part: At present, the automation level of the slitting machine produced in China is still at the middle and lower level. Although the domestic control of the original device has been widely used and the price is lower, the domestic slitter manufacturers are far away in use. It lags behind the level of developed countries, especially in the control system, and the lack of organic combination with the structure of the slitting machine and the material to be cut. At this level, most of the domestic slitting machines still stay on the thick lines. The rigor and rationality of the cutting machine control system has not been fully understood. I personally think that the domestic slitting machine manufacturers should start from the above several directions, and find out the method that meets the cutting and cutting principle of the slitting machine and can maximize the use of the functions provided by the hardware.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com