Automatic Machinery Aluminum Foil Tape Coating Machine

Automatic Machinery Aluminum Foil Tape Coating Machine

1.Main engine & pump full-automatic tracking system and constant tension control system, no matter ensure the coating stability, improve the material compound roughness.

2.Double position for taking up roller and full automatic not reduce changing roller, greatly improve the equipment operation and produce efficiency.

Automatic Machinery Aluminum Foil Tape Coating Machine

Note on the use of the coater:

2.3 Note:
1. Clean the surface of the roller and the coating tool with alcohol before starting the machine.
2. Start the “Scraper Lock” button before adjusting the blade gap. Coating should be carried out in strict accordance with the process requirements to meet the process requirements.

Automatic Machinery Aluminum Foil Tape Coating Machine

Note on the use of the coater:

2.2 Method of operation:
1) Start up and clean the equipment according to the equipment operation regulations.
2) Under the manual correction, wear the belt according to the requirements of the belt, and restore the automatic correction after wearing. 3) Set the coating temperature, coating speed, speed ratio, and blade gap according to the following table.
4) Start each section of the drying tunnel fan and heating equipment, and the coating can be applied until the temperature of the drying tunnel reaches the process.
5) Pre-adjust the blade gap according to the film density requirements and experience, and fine-tune with the feeler gauge to adjust the blade after adjustment.
6) Set parameters such as coating length, interval, fiber positioning and fiber inspection according to the requirements of the process drawings and the type of ingredients.
7) Install the chute and baffle, and set the “forbidden coating” parameter to the effective state, and turn on the “stirring” kinetic energy.
8) When coating, first press “coating roller”, then press “coating”, and finally cancel “forbidden coating”;
9) After the first side is applied, the parameters should be adjusted according to the process requirements. After the temperature is stable, the second side can be driven by the vehicle.
10) During coating, the film length, empty foil length, and sheet weight of the first side and the second side should be measured at any time and recorded.
11) When the coating is stopped, first press “Forbidden Coating”, then cancel “Coating”, and finally cancel “Coating Roller”. 12) Short-term parking should keep “stirring” on, “painting roller” on and set its line speed to 500m/min.
13) The coated pole piece should be placed on a special iron frame and marked with the mark, and transferred to the next process.
14) Shut down according to the requirements of the equipment operation rules, clean the coating roller, scraper and utensils with alcohol, and do 5S work.

 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com