Air Withered Automobile Petrochemical Aluminum Foil Tape Coating Machine

Air Withered Automobile Petrochemical Aluminum Foil Tape Coating Machine

It's be mainly used for bopp film gelatinizing producing,The tape is mainly used to seal the box, seal the cover and bind the articles, and can also be used as office supplies.

Air Withered Automobile Petrochemical Aluminum Foil Tape Coating Machine

Coating machine knowledge handout ---

In the coating process, the coating gap is poor and the pole piece wrinkles are analyzed:

I. The phenomenon and cause of poor coating gap
1. Trailing
(1) Material: slurry material, viscosity, solid content, slurry (surface) tension
(2) Equipment: coating-back roller distance. speed of coating roller when back roller is opened. diameter of back roller. back roller surface material. back roller deformation. back roller and coating roller parallelism. back roller and oven front Rolls are not parallel. Tension in operation
(3) Operational aspects: parameters for head and tail adjustment 2. Head and tail are not parallel
(1) Material: the gravitational pull on both sides of the substrate
(2) Equipment: The back roller and the coating roller are not parallel. The back roller is not open when it is opened. The back roller surface is coaxial. The back roller and the traction roller are not parallel. The level changes. (3) The tension roller adjustment state.

Air Withered Automobile Petrochemical Aluminum Foil Tape Coating Machine

Second, the length of the coating section changes, the spacing is unstable:

3. Reasons and countermeasures for the phenomenon of wrinkling of the pole piece during the operation of the coater
1. The overall installation accuracy is low. The installation center of each component deviates from the center line of the whole machine design, or it has an angle with the design center. The foil strip will be seriously wrinkled and the installation center must be adjusted.
2. The excessive parallelism between the rollers will cause the foil strip to wrinkle. It is necessary to check carefully whether the vertical projection surfaces are not parallel or the horizontal plane is not parallel, and then adjust.
3. The roughness of the surface of the roller is too poor, the surface of the roller is not smooth enough, and the foil is wrinkled when there is obvious processing texture. It needs to be replaced by the manufacturer.
4. The back roller and each roller are stuck with foreign matter or use too much water. Isopropyl alcohol scrubbing requires frequent inspection, timely detection and cleaning, and careful not to damage the roller surface.
5. The foil strip joint is not good. When the tension between the two sides of the foil strip is unbalanced, the pole piece is wrinkled. First adjust the tension adjusting roller under the coating head. After the foil strip is gradually stable, adjust the adjusting roller to the original state.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com