Automatic Release Paper Film Coating Machine

Automatic Release Paper Film Coating Machine

It is suitable for manufacturing hot stamping film, laser film, gold and silver paperboard which need coating and laminating. 
 

Automatic Release Paper Film Coating Machine

Coating operation process --

Before starting the machine, cut the PET film required for coating according to the size; check whether the coating roller, back roller and knife roller are clean. (Other auxiliary rollers include oven and also check)
? Check whether the belt is correct before and after, and whether the aluminum foil is wrinkled. Once found, correct it in time.
? Open air, open power (total power)
? Turn on the phone, press the touch screen tension button, and correct the button (and set the front and rear correction to auto-correction)
? Set the coating speed (pre-set, and then set according to the viscosity of the slurry and the humidity after drying)
? Click the heating button to preheat the drying tunnel (usually turn on the heating 30 minutes before the coating, the heating temperature can be adjusted according to the actual condition)

Automatic Release Paper Film Coating Machine

Coating operation process --

 

? Pre-adjust the gap gap

2. Adjust the gap between the coating roller and the knife roller. The general gap is between 300 and 400 microns. The specific adjustment is to adjust the clearance by turning the screw (the rotating screw is to rotate both sides at the same time)
? Apply PET film and set the coating width (Note: PET film must be firmly bonded with transparent tape, the coating width is based on the outlet of the slurry)
? Fix the waste pallet, the retaining plate, and carry out the trial coating (single-sided first inspection: whether the coating is dried, whether the coating width is correct, the width of the tabs on both sides, and the areal density)
? Formal coating (provided that all parameters and dimensions are correct), inspection ? Double-sided first inspection (including symmetry, double-sided density, etc.)
? When applying the other side, the strap must be firm (with aluminum foil tape), stop coating, stop heating, remove the coated aluminum copper foil, put it into the oven and heat it in vacuum.
? Turn off the machine, turn off the power, air supply, and clean the equipment.
? Put used tools in place and clean them off work.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com