Chocolate Coating Machine

Chocolate Coating Machine

It is suitable for manufacturing hot stamping film, laser film, gold and silver paperboard which need coating and laminating. 
 

Chocolate Coating Machine

Note on the use of the coater:

1. Coating machine equipment operating procedures
In order to ensure safe production and maintain the normal operation of the coater, this operation procedure is specially formulated:
1.1 Preparation before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame (such as electric furnace) in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio (usually 20 to 50) on the tension controller.
3) Set the coating working mode and related parameters (coating speed, length, gap length, roller speed ratio, etc.), and then turn on the compressed air (adjust the pneumatic control box pressure regulating valve to make the pneumatic pressure 0.2 to 0.3Mpa) Between)
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.

Chocolate Coating Machine

Note on the use of the coater:

2. Coating procedure
2.1 Process requirements:
1) The first coating length deviation is ≤ 1 mm, and the coating gap deviation is ≤ 1 mm.
2) The maximum misalignment between the second side and the first side is ≤ 0.5 mm.
3) The maximum deviation of the thickness of the coated single film is ≤ 2 um, and the maximum deviation of the thickness of the double film is ≤ 3 um. 4) The maximum deviation of the density of the coated single film is ≤ 3%, and the maximum deviation of the density of the double film is ≤ 3%. 5) The maximum error of coating tailing is ≤1mm.
6) The film surface should be flat and free from cracks, cracks, granules and streaks.
7) Coating width = single strip width multiplied by the maximum number of coatables + 5 ~ 10mm.

 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com