Release Paper Production Line Making Coating Machine

Release Paper Production Line Making Coating Machine

1. Moveable blade device. 
2. Guiding roller in oven will synchronously rotates with main shaft. 
3. Solenoid operated valve controlling is adopted for Anilx roller and drawing roller. 
4. Automatic meter-measuring devices. 
5. Key mode air shaft is used for unwinding and rewinding shafts, easy to load and unload. 

Release Paper Production Line Making Coating Machine

Note on the use of the coater:

1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.
1.4 Notes
1) Operators must undergo pre-job training and pass the assessment before they can be employed, and should strictly abide by these operating procedures.
2) Except for the necessary maintenance personnel, it is strictly forbidden for non-personnel personnel to operate the equipment or change the setting parameters.
3) The roller speed ratio is recommended to be set within the range of 1.3 to 1.5.
4) It must be confirmed that the air heater has not been activated until the drying fan has been started.

Release Paper Production Line Making Coating Machine

Coating operation process --

 

? Pre-adjust the gap gap

2. Adjust the gap between the coating roller and the knife roller. The general gap is between 300 and 400 microns. The specific adjustment is to adjust the clearance by turning the screw (the rotating screw is to rotate both sides at the same time)
? Apply PET film and set the coating width (Note: PET film must be firmly bonded with transparent tape, the coating width is based on the outlet of the slurry)
? Fix the waste pallet, the retaining plate, and carry out the trial coating (single-sided first inspection: whether the coating is dried, whether the coating width is correct, the width of the tabs on both sides, and the areal density)
? Formal coating (provided that all parameters and dimensions are correct), inspection ? Double-sided first inspection (including symmetry, double-sided density, etc.)
? When applying the other side, the strap must be firm (with aluminum foil tape), stop coating, stop heating, remove the coated aluminum copper foil, put it into the oven and heat it in vacuum.
? Turn off the machine, turn off the power, air supply, and clean the equipment.
? Put used tools in place and clean them off work.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com