It's be mainly used for bopp film gelatinizing producing，The tape is mainly used to seal the box, seal the cover and bind the articles, and can also be used as office supplies.
Note on the use of the coater:
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.
1) Operators must undergo pre-job training and pass the assessment before they can be employed, and should strictly abide by these operating procedures.
2) Except for the necessary maintenance personnel, it is strictly forbidden for non-personnel personnel to operate the equipment or change the setting parameters.
3) The roller speed ratio is recommended to be set within the range of 1.3 to 1.5.
4) It must be confirmed that the air heater has not been activated until the drying fan has been started.
Coating operation process --
? Pre-adjust the gap gap
1. Adjust the gap between the back roller and the coating roller. The gap is generally the thickness of the two layers of aluminum foil and copper foil (note: the adjustment of the roll gap on both sides is basically the same). The actual adjustment of the roll gap can be adjusted to adjust the specific parameters in the pushing device. The program is automatically saved once, and no adjustment is needed next time.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc