Film Coating Mahchine

Film Coating Mahchine

1. High precision alloy steel die head make sure the customer can get the best coating effection.

2. Total Machine is controlled by  PLC.Precision control coating speed and glue amount.

3. Increase the film function in some glue or substrate is not suitable for direct knife coating that realize 2 kinds of craftwork (knife coating and film coating.) on one machine.

Film Coating Mahchine

Second, the length of the coating section changes, the spacing is unstable:

3. Reasons and countermeasures for the phenomenon of wrinkling of the pole piece during the operation of the coater
1. The overall installation accuracy is low. The installation center of each component deviates from the center line of the whole machine design, or it has an angle with the design center. The foil strip will be seriously wrinkled and the installation center must be adjusted.
2. The excessive parallelism between the rollers will cause the foil strip to wrinkle. It is necessary to check carefully whether the vertical projection surfaces are not parallel or the horizontal plane is not parallel, and then adjust.
3. The roughness of the surface of the roller is too poor, the surface of the roller is not smooth enough, and the foil is wrinkled when there is obvious processing texture. It needs to be replaced by the manufacturer.
4. The back roller and each roller are stuck with foreign matter or use too much water. Isopropyl alcohol scrubbing requires frequent inspection, timely detection and cleaning, and careful not to damage the roller surface.
5. The foil strip joint is not good. When the tension between the two sides of the foil strip is unbalanced, the pole piece is wrinkled. First adjust the tension adjusting roller under the coating head. After the foil strip is gradually stable, adjust the adjusting roller to the original state.

Film Coating Mahchine

BOPP film data --

Advantages of BOPP film:
BOPP film is a very important flexible packaging material. BOPP film is colorless, odorless, tasteless, non-toxic, and has high tensile strength, impact strength, rigidity, toughness and good transparency.
BOPP film has low surface energy and needs corona treatment before coating or printing. After corona treatment, the BOPP film has good printing adaptability, can be printed in color, and has a beautiful appearance effect, and thus is often used as a surface layer material of the composite film.
Insufficient BOPP film:
BOPP films are also insufficient, such as easy accumulation of static electricity, no heat sealability, and the like. In high-speed production lines, BOPP film is prone to static electricity, and an electrostatic remover is required. In order to obtain a heat-sealable BOPP film, a heat-sealable resin glue such as PVDC latex, EVA latex, etc. may be applied after corona treatment on the surface of the BOPP film, or a solvent glue may be applied, or extrusion coating or The co-extruded composite method produces a heat sealable BOPP film. The film is widely used in the packaging of bread, clothes, shoes and socks, as well as the cover of cigarettes and books. The initial tear strength of the BOPP film is improved after stretching, but the secondary tear strength is very low. Therefore, no cuts can be left on both end faces of the BOPP film, otherwise the BOPP film is easily torn during printing and compounding. BOPP can produce sealing tape after coating self-adhesive, which is a market with a large amount of BOPP.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?