1. High precision alloy steel die head make sure the customer can get the best coating effection.
2. Total Machine is controlled by PLC.Precision control coating speed and glue amount.
3. Increase the film function in some glue or substrate is not suitable for direct knife coating that realize 2 kinds of craftwork (knife coating and film coating.) on one machine.
Second, the length of the coating section changes, the spacing is unstable:
6. When the back roller and the coating roller are in contact with each other, the gap between the two ends is inconsistent and the pole piece is wrinkled. Regardless of whether the first side or the second side is applied, the gap should be carefully adjusted. First, the gap is appropriately enlarged, and then slowly reduced. At the same time, observe the dial scale of the coating roller just touching the foil strip, and then Reduce the gap by 0.03mm.
7. When the correction system is abnormal, the pole piece will be wrinkled. Check the three correction systems before and after the inspection, whether it is in the automatic state. If the lengths of the foil strips are inconsistent, that is, when the file is bent too much, the pole pieces will be wrinkled. Exceeding the correcting ability, the foil has to be replaced. 8. When the pole piece tension is too large, the pole piece is wrinkled. Check that the tension setting is reasonable. Then check each drive roller. The rotation of the take-up roll is flexible. Handle inflexible rollers in time.
9. When the back roller is in the inconsistent stroke, the pole piece is wrinkled. It is necessary for the mechanic to check. Confirm and adjust. After the back roller and the coating roller are pulled apart, the gap between the two sides is 1mm (see the dial indicator), and the test is started. When the tail is qualified, lock the nut.
10. The surface of the rubber roller on the back roller will undergo periodic elastic deformation during re-use. When a certain degree of deformation remains, wrinkles will occur. At this time, new products must be replaced.
11. The cause of looseness of a certain roller fastening screw causes the parallel state of each roller to be destroyed, and wrinkles may occur at this time. As long as it is found in time to adjust and tighten in time.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc
gl006@guolianjixie.com