Slitting machine use：
Applicable to BOPP / PVC / PE / textured paper / imported high-end double-sided tape / kraft paper tape / conductive foam plastic / cloth / industrial tape / protective film and other cutting.
Slitting machine operating procedures -
Third, through the film：
13. After all the paper cores on both sides are glued, press “Crop 1 Clamp” and “Reel 2 Clamp” at the same time, and then press “Rewind side 1 open” and “winding side 2 open” at the same time. The position is automatically swung until the winding paper core is pressed against the upper roller, the winding main body is started, and the film is slowly wound until it is tight. (The two-button white indicator light turns from blinking to steady light)
Causes, countermeasures and effects on the quality of BOPP film slitting quality ---
(2) The purpose, method and characteristics of hardness testing
3. Method for detecting film roll hardness
1 selection of testing equipment
There are various instruments for detecting the hardness of an object, but so far there has not been a hardness tester that professionally detects the hardness of a film roll. Due to the large difference in surface hardness between various objects and the variety of hardness testers, it is important to select a hardness tester that can effectively reflect the tightness of the film roll. After screening and comparison, our company has determined the "A-type rubber hardness tester" for detecting the surface hardness of rubber products as an auxiliary instrument for detecting the tightness of the film roll.
2 detection instrument correction
Since the "A type rubber hardness tester" is not a special test instrument for the film roll, in order to improve the detection accuracy of the instrument, we have modified the structure of the hardness tester according to the characteristics of the film, and increased the presser area by 5 times.
3 detection methods a.
Before the test, the pointer of the hardness tester should be in the free state and point to the zero position. When pressing the hardness tester on the glass plate, the pointer should be 100 degrees (the end face of the press pin and the bottom of the foot are in close contact with the glass). If the zero position and the 100 degree are not indicated, the needle can be pressed slightly several times, if not When referring to zero and 100 degrees, it cannot be used. The hardness tester to be confirmed can be used again if it meets the requirements for use. b.
When testing the hardness, put the hardness tester on the side of the film product, take the left, middle and right positions, at least 40mm from the edge of the film roll, and firmly press the end of the hardness tester with both hands, so that the pressure pin is pressed vertically. The sample is read within 1 s until the pressure is fully contacted with the sample, and the average is taken and recorded.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc