Seal Tape Slitter Machine
Tape cutting machine range:
1. Applicable substrate: mica tape, paper, insulation material and film slitting
2, applicable industry: related industries with various insulating materials, special electrical paper, film
3. Applicable technology: sub-distribution, finished product inspection, finished product sub-volume, process cutting
Slitting machine operating procedures -
Third, through the film：
9. Press “Device Jog” again, and the film on both sides will be flattened until the slitting film appears on the winding side 2, and the film is cut with a knife.
10. Manually pull the slit film on the winding side 1 and the winding side 2, bond the film to the corresponding paper core, and tighten the film and stick the flat film to the paper core (note the side 1 and side 2 films). Wearing different methods).
11. Manually adjust the leading edge probe into position.
12. Set the winding length and winding diameter on the operation screen (see the preset length and diameter method for details)
Causes, countermeasures and effects on the quality of BOPP film slitting quality ---
two. Wrinkle (wrinkle, vertical wrinkle, cross wrinkle, line wrinkle)
Through many years, the BOPP industry has carried out a series of intensive and meticulous work on solving the problem of wrinkling. From the two aspects of process parameter screening and equipment adjustment and transformation, we have found a set of effective solutions and received very good results. effect,
5 Under the same parameters, the long gauge is more likely to wrinkle than the short gauge film roll, which means that the longer the specification, the worse the exhaust effect, and the lower the strength of the long gauge paper tube, the slitting process paper The slight bending of the tube tends to cause the film in the middle of the film roll to wrinkle for a long time, and when the paper core is long, under the high-speed rotation of the slit, as the axis of the film winding, its straightness, concentricity, strength, The indicators such as surface finish are the most important. Generally speaking, the longer the paper core, the more difficult it is to ensure the straightness and concentricity. Therefore, the quality of the paper core is very important. It is necessary to improve the inspection of the paper core. If the paper tube is found during the slitting process, the paper tube is found. The quality is abnormal and needs to be replaced in time. In addition, under the same parameter conditions, the short gauge is more prone to deviation than the long gauge membrane coil, and a large winding pressure is required. Therefore, for the adjustment of the wrinkle, the wrinkle can be reduced by appropriately reducing the pressure setting for the long specification, and the pressure is increased for the short specification to prevent the deviation;
6 Different thickness films have different degrees of wrinkling, thick film stiffness is better, less wrinkles, thin film is more open, so the thin film should be adjusted to increase the strength of the parameters to overcome For the generation of wrinkles, different thickness of the film should have different special data for slitting;
7 The product that is slit inside and outside the slitting machine may have different degrees of wrinkling due to the different angles (wrap angles) entering the winding roller. The difference between the inner and outer wrinkles of each slitting machine should be compared, such as The difference is obvious. During the slitting process, the specification that is prone to wrinkle should be cut on the side that is not prone to wrinkle;
8 The wrinkle reduction can also be achieved by adjusting the venting performance of the pressure roller and improving the stability of the winding arm.