Opp Packaging Tape Slitter

Opp Packaging Tape Slitter

Introduction to slitting machine:
     Slitting machine is a kind of mechanical equipment for slitting wide sheets of paper or film into a plurality of narrow-width materials, which are commonly used in papermaking machinery and printing and packaging machinery.
     The traditional control scheme of the slitter is to use a large motor to drive the shaft of the rewinding and unwinding. A magnetic powder clutch is added to the reel and reel, and the resistance generated by the magnetic clutch is controlled to control the tension of the surface of the material. . Magnetic powder clutches and brakes are special automatic actuators that transmit torque through the magnetic powder filled in the working gap. The magnetic current can be changed to change the magnetic state of the magnetic powder, and then the transmitted torque can be adjusted. It can be used for stepless speed regulation from zero to synchronous speed. It is suitable for high speed section fine adjustment and medium and small power speed control system. It is also used to adjust the torque by adjusting the current to ensure an unwinding or rewinding tension control system with a constant tension during winding.

Opp Packaging Tape Slitter

Reasons, countermeasures and effects of BOPP film slitting quality ---

nine. Scratch

     In addition, sometimes scratches due to slitting are difficult to detect by the naked eye, but scratches (scratches) will attenuate the corona value of the product. According to experience, the corona value is reduced by about half in the normal cutting process. Dyne, when the corona values ??differ by more than one dyne before and after cutting, the reasons for the cutting process, such as the speed ratio of the driving roller, the quality of the sand skin, the condition of the sipe roll, etc., should be checked to eliminate the influence. .
     It is worth mentioning that there is a kind of abrasion that is caused by the slitting process, but it is mainly caused by the cutting factor. It is mainly that the mother roll is too loose, and the product of the loose part is horizontally or vertically tilted during the slitting process. While scratching the film surface, it is found that the phenomenon is to install the upper splint on the mother roll for positioning, and secondly, the cutting speed should be properly controlled, and the influence of the quality of the mother roll on the cutting quality can be improved as much as possible.

Opp Packaging Tape Slitter

Reasons, countermeasures and effects of BOPP film slitting quality ---

ten. Color circle
The color circle is caused by a certain degree of contamination inside or outside the film, which causes the quality of the color circle on the end face of the film roll after slitting and winding. Membrane surface pollution sources come from two aspects. One is the film-forming process. The color circles generated in the front part of the film, such as raw materials, feeding systems, extrusion systems, and die flow channels, generally cause pollution to the inside of the film (core layer). Some color-circle products can clearly observe a large amount of fish-eye impurities in the film. The color circles generated in the film-forming stage and the slitting process mainly cause pollution to the outside (surface) of the film, but whether it is internal or external pollution, It is impossible to remove the impurities from the contaminated film and restore the original appearance. The product with serious color circle has low transparency, the film color is different from the normal product, and it can not be used at all. It can only be reduced to other external treatments, while the products with slight color circles are It has little effect on the transparency of the product and does not affect the use effect of the single film. However, due to the inconspicuous appearance of the color circle product, the “selling phase” is poor, which has a great influence on the image of the German brand. It is not suitable for direct delivery. Secondary processing. If the color circle is caused by external dust pollution factors, the dust will be adsorbed on the surface of the film, resulting in poor quality of heat sealing and poor laser compression.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com