Slitter Rewinder Machine For Tape

Slitter Rewinder Machine For Tape

Preparation of slitter cutter
1. Razor slitting
1.1. The razor slitting requires the film to travel in the correct direction to the winding section.
1.2. Adjust the photoelectric tracking to bring the film to the proper position.
1.3. Tension the film and attach the blade to the razor holder.
1.4. According to the specifications required by the instruction sheet, the sliding razor holder is cut into the razor groove under the film, and the blade edge and the edge of the sipe are required to be in contact with each other.
1.5 After adjusting the depth of the cutter, lock the razor frame screws.
2. Round knife cutting
2.1. Check whether the upper and lower knives are sharp and have no gaps, and vice versa;
2.2. Determine the number of knives (N+1) according to the number of product series (N);
2.3. Install the lower knife to adjust the width of the lower knife according to the actual width of the product;
2.4 Install the upper knife correctly. The flat side of the upper knife is aligned with the side of the lower cutting edge. The upper knife is aligned with the gap between the lower knife and the septum. Press the screws on both sides to make the upper knife enter the gap depth to about 2mm. The upper knife is attached to the lower knife and fastened. Finally, the screw on the left side of the upper knife holder is adjusted so that the whole knife holder moves 1-2 mm to the right side and is fastened.

Slitter Rewinder Machine For Tape

Reasons, countermeasures and effects of BOPP film slitting quality ---

four. Deviation
Deviation refers to the phenomenon that part of the film on the end face of the film roll is misaligned, which is caused by the sliding of the film during the winding process.

1. The effect of deviation on usage
The effect of deviation on the use is basically the same as that of the end face, which is mainly to track the problem of alignment and the influence on the appearance of the product. Because the degree of misalignment of the deviation is much more obvious than that of the end face, it does not meet the requirements of the customer. Therefore, it must be processed twice, and it can be graded and packed into the warehouse after meeting the requirements.

Slitter Rewinder Machine For Tape

Reasons, countermeasures and effects of BOPP film slitting quality ---

Fives. Multilateral
Although the polygon and the end face are not the same as the faulty end faces of some layers of the film roll, the two are different. The unevenness of the end face is the jagged phenomenon that occurs when the film width is not changed, and the multilateral product The film width is slightly wider than the normal size.

1. Multilateral impact on quality of use
The impact of multilateral use on the end is basically the same as that of the end face, mainly to track the problem of alignment and the impact on the appearance of the product.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com