Bopp Sealing Tape Slitting Machine

Bopp Sealing Tape Slitting Machine

Preparation of slitter cutter
1. Razor slitting
1.1. The razor slitting requires the film to travel in the correct direction to the winding section.
1.2. Adjust the photoelectric tracking to bring the film to the proper position.
1.3. Tension the film and attach the blade to the razor holder.
1.4. According to the specifications required by the instruction sheet, the sliding razor holder is cut into the razor groove under the film, and the blade edge and the edge of the sipe are required to be in contact with each other.
1.5 After adjusting the depth of the cutter, lock the razor frame screws.
2. Round knife cutting
2.1. Check whether the upper and lower knives are sharp and have no gaps, and vice versa;
2.2. Determine the number of knives (N+1) according to the number of product series (N);
2.3. Install the lower knife to adjust the width of the lower knife according to the actual width of the product;
2.4 Install the upper knife correctly. The flat side of the upper knife is aligned with the side of the lower cutting edge. The upper knife is aligned with the gap between the lower knife and the septum. Press the screws on both sides to make the upper knife enter the gap depth to about 2mm. The upper knife is attached to the lower knife and fastened. Finally, the screw on the left side of the upper knife holder is adjusted so that the whole knife holder moves 1-2 mm to the right side and is fastened.

Bopp Sealing Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)
1. Interface requirements
Due to poor interface, the quality of the film roll may be broken or wrinkled, which may cause adverse effects in the user's use. Therefore, the film interface must be connected to the specified specification to ensure the joint quality of the interface. Specific requirements are as follows: 
1 The two sections of the joint are cut and flattened horizontally, and the beige (or other specified color) adhesive tape with a width of 72 mm is firmly adhered to the front and back sides of the film;
2 In order to improve the interface quality, the film interface is required to be straight and balanced with the paper tube direction, and the interface is required to be flush and wavy. The interfaces at both ends are in the middle of the tape. Try to avoid the size of the edge. The adhesive tape is attached to the film. No obvious bubbles;
3 The film surface at the interface is required to be smooth without obvious wrinkling;
4 Do the identification of the joint position as specified.

Bopp Sealing Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)

3. Interface length and interface rate requirements
Since the interface products will inevitably generate certain scraps before and after the interface, and the quality of the interface products cannot reach 100% of the quality level of the interfaceless products, increasing the loss of use, therefore, the film manufacturers and users are The number of interfaces of the volume product and the interface ratio of each batch of products are specified, so that the interface products are controlled within a certain range.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com