Bopp Adhesive Tape Slitting And Rewinding Machine

Bopp Adhesive Tape Slitting And Rewinding Machine

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Bopp Adhesive Tape Slitting And Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

four. Deviation
Deviation refers to the phenomenon that part of the film on the end face of the film roll is misaligned, which is caused by the sliding of the film during the winding process.

1. The effect of deviation on usage
The effect of deviation on the use is basically the same as that of the end face, which is mainly to track the problem of alignment and the influence on the appearance of the product. Because the degree of misalignment of the deviation is much more obvious than that of the end face, it does not meet the requirements of the customer. Therefore, it must be processed twice, and it can be graded and packed into the warehouse after meeting the requirements.

Bopp Adhesive Tape Slitting And Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Fives. Multilateral

2. The causes and countermeasures of multilateralism:
(1) The mother roll is seriously deviated, wrinkled or uneven in thickness. When the film runs to the sipe roll, it does not stick to the roller and appears multilateral. It is necessary to improve the quality of film production.
(2) Due to the looseness of the parent roll, the floating roller in the slitting process fails to compensate for the slack in the mother roll in time to cause multilateral occurrence. At this time, it is necessary to accelerate to cope with the problem.
(2) The film roll is not effectively adjusted for the bending roll or the high and low roll or the pull wheel, and the flatness of the film during the slitting process must be improved by effective adjustment;
(3) The blade material does not meet the requirements for use, and the texture is too soft or the friction is deformed by heat. Replace the qualified blade;
(4) Poor cutting control, such as too fast slitting speed, slitting speed and poor sheet/pressure setting. Reasonable adjustment.
(5) The process of slitting due to the loss of sand skin can also cause wrinkles and a multilateral phenomenon.
(6) If the unwinding tension is too small, it will also cause multilateral phenomena.

 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com