Roll To Roll Automatic Slitting Machine

Roll To Roll Automatic Slitting Machine

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Roll To Roll Automatic Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

four. Deviation
Deviation refers to the phenomenon that part of the film on the end face of the film roll is misaligned, which is caused by the sliding of the film during the winding process.

2. Causes and countermeasures of deviation:
(1) The problem of the quality of the slitting in the same category as the deviation of the end face is, in terms of degree, the degree of misalignment is more serious than the misalignment of the end face; in terms of nature, the general end face is not a continuous problem. However, the deviation is mostly an accidental problem; from the analysis of the reasons, the cause of the unevenness of the end face may cause the occurrence of the deviation problem.
(2) Since the deviation of the deviation from the end face is more prominent, the eye point should be placed in the fine point when the end face is not aligned. When analyzing the deviation problem, the eye point should be widened, especially the factor of the cutting speed. The effect is that the acceleration and deceleration are too rapid. For a film with good smoothness, it is easy to cause slippage and cause a split layer, and the slitting speed should be slowed down.
(3) For products with narrow slitting, too tight winding of the film roll will cause the film to slip laterally. If the film roll is too loose, air will be trapped, which will cause the film roll end to be staggered. Roll tension.

Roll To Roll Automatic Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Fives. Multilateral
Although the polygon and the end face are not the same as the faulty end faces of some layers of the film roll, the two are different. The unevenness of the end face is the jagged phenomenon that occurs when the film width is not changed, and the multilateral product The film width is slightly wider than the normal size.

1. Multilateral impact on quality of use
The impact of multilateral use on the end is basically the same as that of the end face, mainly to track the problem of alignment and the impact on the appearance of the product.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com