Small Tape Slitting Machine

Small Tape Slitting Machine

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Small Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

 

six. Burr

The raw edge product not only affects the appearance, but also directly affects the use. The edging product is observed with a magnifying glass. The edge of the film is jagged. The film roll is prone to breakage during use, and the consequences are very serious. For example, if the printed film breaks during the printing process, the ink will be caused. Splash, need to clean the machine and the ground, and then lead the film, re-coloring and other processes, production of physical and working loss; if the tape film breaks during the coating process, it is necessary to open the oven more than ten meters, re-introduction Membrane, turn off the oven, heat up and reproduce. These are things that users are very annoying and we must pay attention to.

In addition, we must pay attention to the protection of the end face during the moving process of the film roll, the film end face gap caused by the operation accident, and the gap has high concealment, the problem is difficult to find and flow to the user, the product will be Use has a greater impact.

Small Tape Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

eleven. Width deviation is too large
     The width of the film roll is limited by the gap of the sipe roll. The actual slit width will deviate from the width required for the order, but the deviation should be controlled within the tolerance range of ±2mm required by the national standard. The so-called width deviation Large, that is, the actual width of the film roll exceeds the requirements of internal control standards or customer standards.
     Not all products have a tolerance of ±2mm, and some customers can only take deviations from the film width, such as the Pd film of Kunshan Zhangpu, the LL film of Shanghai Zhicheng, the PL film of Beijing Amcor, etc. It is required to adjust the film width.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com