1300 Bopp Tape Automatic Slitter Rewinder

1300 Bopp Tape Automatic Slitter Rewinder

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

1300 Bopp Tape Automatic Slitter Rewinder

Reasons, countermeasures and effects of BOPP film slitting quality ---

Eight. Indentation
There are two reasons for the cause of film roll indentation. One is caused by the winding wheel of the film forming process, and the other is caused by the cutting factor. The reasons for the cutting are:
1 Due to the poor adjustment of the angle of the puller wheel, the pressure and tension of the puller wheel are concentrated on one point of the film, and the friction of the contact point causes damage to the film surface to form an indentation.
2 The winding roller is damaged, such as scratches, etc., the degree of film roll indentation is large when the scratch is longitudinal; 3 The winding roller is contaminated, causing the surface of the pressure roller to be uneven, such as adhesive tape, impurities, etc. It will also cause the film roll to be indented and the press roll must be cleaned.
Slight indentation does not affect the use of the product, but it affects the appearance of the product, causing the customer to doubt the quality of the product; the obvious indentation not only affects the appearance of the product, but also attenuates the corona value of the film, affecting the film. Processing performance.

1300 Bopp Tape Automatic Slitter Rewinder

Reasons, countermeasures and effects of BOPP film slitting quality ---

ten. Color circle
The color circle is caused by a certain degree of contamination inside or outside the film, which causes the quality of the color circle on the end face of the film roll after slitting and winding. Membrane surface pollution sources come from two aspects. One is the film-forming process. The color circles generated in the front part of the film, such as raw materials, feeding systems, extrusion systems, and die flow channels, generally cause pollution to the inside of the film (core layer). Some color-circle products can clearly observe a large amount of fish-eye impurities in the film. The color circles generated in the film-forming stage and the slitting process mainly cause pollution to the outside (surface) of the film, but whether it is internal or external pollution, It is impossible to remove the impurities from the contaminated film and restore the original appearance. The product with serious color circle has low transparency, the film color is different from the normal product, and it can not be used at all. It can only be reduced to other external treatments, while the products with slight color circles are It has little effect on the transparency of the product and does not affect the use effect of the single film. However, due to the inconspicuous appearance of the color circle product, the “selling phase” is poor, which has a great influence on the image of the German brand. It is not suitable for direct delivery. Secondary processing. If the color circle is caused by external dust pollution factors, the dust will be adsorbed on the surface of the film, resulting in poor quality of heat sealing and poor laser compression.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com