Packing Tape Slitting And Rewinding Machine

Packing Tape Slitting And Rewinding Machine

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Packing Tape Slitting And Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

nine. Scratch
      Whether the slitting and scratching can be compared and determined by the film surface before and after the slitting, there are various reasons for the scratching of the membrane surface, and the analysis should be based on the appearance of the scratch, such as short-line scratching. The difference of the speed ratio of each drive roller exceeds the process setting requirement, and it needs to be carefully tested and adjusted. If the film surface scratch occurs continuously, the film on the slitter should be inspected for whether it touches the fixed object or cuts each. Whether the roller adheres to dirt such as fine sand grains scratches the film surface.
Scratch is the appearance quality problem of the film, which directly affects the quality appearance of the deep-processed product. Therefore, it is not allowed to exist in the film quality control standard. The slitting process finds that the scratching problem must be carefully checked and quickly eliminated. Since the scratch on the film surface is an irreversible appearance quality problem, it is not allowed to operate the disease when the film surface is scratched, so as to avoid the continuous occurrence of the problem.
      

Packing Tape Slitting And Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

nine. Scratch

     In addition, sometimes scratches due to slitting are difficult to detect by the naked eye, but scratches (scratches) will attenuate the corona value of the product. According to experience, the corona value is reduced by about half in the normal cutting process. Dyne, when the corona values ??differ by more than one dyne before and after cutting, the reasons for the cutting process, such as the speed ratio of the driving roller, the quality of the sand skin, the condition of the sipe roll, etc., should be checked to eliminate the influence. .
     It is worth mentioning that there is a kind of abrasion that is caused by the slitting process, but it is mainly caused by the cutting factor. It is mainly that the mother roll is too loose, and the product of the loose part is horizontally or vertically tilted during the slitting process. While scratching the film surface, it is found that the phenomenon is to install the upper splint on the mother roll for positioning, and secondly, the cutting speed should be properly controlled, and the influence of the quality of the mother roll on the cutting quality can be improved as much as possible.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com