Duck Tape Machine

Duck Tape Machine

Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.

Duck Tape Machine

Semi-automatic cutting machine technical operation rules

7. Regular inspection of accuracy and variability
7.1 Detect the positive and negative turbulence of the main motion clutch after it is closed. The value is less than 2.0mm.
7.2 Detecting the running speed adjustment range of the host: the minimum speed is not more than 50mm/min, and the maximum speed is not less than 120mm/min.
7.3 Detecting the gas path part includes the connection of the connecting hose: air tightness: oxygen closed circuit 1.2Mpa, mixed gas path: 0.6 Mpa voltage regulation for 20 seconds shall not leak.
7.4 Detecting the thickness range of the cut steel plate: 10-100mm is acceptable.
7.5 Flame burning test of the torch (visible cutting oxygen flow length): 1#≥70mm; 2#≥90mm;3#≥100mm.
8. Daily maintenance regulations
8.1 After cutting the mouth, pay attention to the protective cover of the fashion, and do not bump.
8.2 Pay special attention to moisture when using and storing.
8.3 The lubricant in the gearbox should be replaced in time.

Duck Tape Machine

Semi-automatic cutting machine technical operation rules
1. Scope of application
The semi-automatic cutting machine is a device for cutting medium and low carbon steel by flame using oxygen-acetylene (medium and low pressure) as a heat source. The machine can cut the straight line, the circle and the arc and the left and right 45 degree groove.
2. Qualification requirements for operators
2.1 The operator of the machine must be trained in safety professional skills.
2.2 The operator must understand how the machine is used and can handle faults that occur during operation.
3. Mechanical requirements for the working environment
3.1 This machine should not be used and stored in high humidity and high corrosion environment.
3.2 It is not advisable to carry out open-air operations in rainy and snowy weather and windy weather. If necessary, cover measures should be adopted.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com