Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.
Guolian Machinery -- GL-5000 Tape Cutting Machine
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.
Cutting length: 5 ~ 999 mm
Tape width: 6 ~ 50 mm
Maximum outer diameter: 300 mm
Speed: 200 mm/min
Weight: 2.8 kg
Size: 115mm X 140mm X 215mm
utomatic tape tape cutting machine ---
With the continuous development of industrial technology, traditional manual work such as cutting tape is now replaced by machines. Tape cutting machine is also called adhesive paper cutting machine and tape machine.
Cutting length: between 3-999mm
Cutting width: between 3-100mm
Such an automatic adhesive tape cutting machine can be used in the production and packaging processes of electronics, machinery and other factories: labeling, fixing, etc., can greatly improve work efficiency, save labor costs, and ensure the quality of work.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc