Duck Tape Machine Price

Duck Tape Machine Price

Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.

Duck Tape Machine Price

Automatic tape cutting machine --- Working principle

The automatic tape cutting machine is a small-scale automation device that is used on the assembly line to greatly improve production efficiency. There are basically two types: mechanical and electronic.
The mechanical type is disc type, and the common models are ZCUT-2 and upgraded zcut-8. The zcut-8 is favored by users because of its smaller size and more precise cutting.
The commonly used electronic models are M-1000 and ZCUT-9. Among them, ZCUT-9 tape cutting machine is more and more accepted by customers because of its precise cutting and easy maintenance.

Duck Tape Machine Price

GL-5000 tape cutter to cut two kinds of tape at the same time steps and precautions
If the tape width is less than 10 mm, insert the divider. This model can cut two tapes with a width of less than 25 mm at the same time.
1. Remove the divider from the bottom of the machine.
2. Press the press cover button to open the press cover.
3. If the tape width is less than 10 mm, insert the auxiliary spacer.
! Remove the auxiliary divider from the bottom of the machine and insert it into the junction of the divider.
4. Install the tape roll and move the width bar to adjust the tightness of the guide plate.
5. Import the tape and set the working mode.
! In the automatic mode, when cutting two sets of tape, take two pieces of tape and the machine will cut the two pieces of tape.
*note
1. Forcibly cutting high-adhesive tape will affect the service life of the motor.
2. After using the divider and auxiliary dividers, return to the bottom of the machine.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com