Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.
Single shaft automatic foam tape slitting cutting machine:
The machine is suitable for cutting BOPP tapes, PVC tapes, PE tapes, masking paper tapes, double sided tapes, kraft paper tapes, foam tapes, duct tapes, industrial tapes, protective film, etc.
1) Easy to operate.
2) Silicon solution cooling system, avoiding cutter getting sticky which can make sure that the cutting process are all right.
3) Accurate cutting position: using servo motor to drive, used with perfect ball screw, lineary or bit to make sure the cutting process accurate and perfect.
4) The face and back tube are supported by oil pressure to ensure the stability of mini pathway when it was cut.
5) Round knife cutting promotes the working efficiency.
BOPP/Masking/Kraft/Foam Tape Automatic Cutting Machine:
Suitable for cutting various tape, such as: BOPP, PVC, PE, masking tape, double sided tape, kraft paper tape, foam tape, industrial tape and paper, film, etc.
1) Cutting shaft and circular blade are driven by MITSUBISH inverter and A.C motor.
2) The acceleration and deceleration are fast and steady and running direction: forward/reverse upon setting.
3) Cutting width setting is controlled by MITSUBISH servo motor, ball screw, guide rails for precise movement.
4) MITSUBISHI PLC programmable central control and all functions operate under LCD touch screen panel which is for all data setting.
5) Knife feeding is controlled by MITSUBISHI servo motor and the cutting speed is adjustable in 3 stages.
6) Circular blade angle auto adjustment is controlled by SANYO step motor or MITSUBISHI servo motor which is used to calculate the circular blade angle and the angle change is subject to different raw materials ( the angle change range is ±8°for single shaft cutting and ±3° for double shafts and four shafts cutting). The cutting angle is changed directly when the cutting surface is not smooth, so the efficiency is improved.
7) Three kinds of shafts size are available, quick change of shafts are suitable for different raw materials.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc