Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.
1300mm jumbo roll width tape manual cutting rewinding machine:
1. Simple structure, convenient operation and maintenance.
2. The power of the whole machine is only 3KW, which saves energy, the motor and the spindle are driven by the triangle belt, and the machine has low running noise.
3. The cutting shaft adopts high quality carbon steel, which is tempered, high frequency quenching and chromium plating (unilateral 0.05 mm). The hardness reaches HRC60, wear-resisting and cutting.
4. The cutting knife is carefully processed by W18Cr4V, with sharp edge and high durability.
Automatic double sided adhesive tape cutting machine:
This machine is suitable for kinds of adhesive tapes or kinds non-viscous material high precision cutting.
Such as the protective film, high tempreture tape, 3M tape, optical film, foam tape, goldfinger tape, green tape and other electronic material.
You can cut different sizes according to different material.
1. Main driving system: AC motor with the frequency inverter.
Make sure the speed up or speed-down fast and steady during log roll cutting.
2. Central control unit: The programmable central control system.
You can cutting multiple sizes in the same log roll.
3. Operating panel: The 10'' big LCD panel.
You can set up various cutting model and monitor the cutting job directly in the panel.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc