High Speed Tape Slicer

High Speed Tape Slicer

Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.

High Speed Tape Slicer

Automatic double sided adhesive tape cutting machine:

  • Function:

This machine is suitable for kinds of adhesive tapes or kinds non-viscous material high precision cutting.

Such as the protective film, high tempreture tape, 3M tape, optical film, foam tape, goldfinger tape, green tape and other electronic material.

You can cut different sizes according to different material.

Features:

4. Motor control system:  The PLC programmable controller.You can set up various cutting size in the same log roll.Can be adjusted cutting size according to the set up cutting width and cutting roll quantity.

5. Cutting size positioning system: The Mitsubishi servo motor control.Make sure the high accuracy of the ball screw and the linear slide rail positioning in the cutting.

6. Feed positioning system: The Hydraulic motor / Mitsubishi servo motor to control the knife feeding.It can be anthropomorphized as a three-step feeding speed of the cutter.
Improve efficiency and get the best quality.

High Speed Tape Slicer

Automatic double sided adhesive tape cutting machine:

  • Function:

This machine is suitable for kinds of adhesive tapes or kinds non-viscous material high precision cutting.

Such as the protective film, high tempreture tape, 3M tape, optical film, foam tape, goldfinger tape, green tape and other electronic material.

You can cut different sizes according to different material.

Features:

7. Round knife Angle adjustment system ( optional)The Mitsubishi servo motor control to calculate the circular knife Angle.According to different materials to do different angles change (adjustment range: + / -8 °  ) .If the cutting surface is not good, you can change the cutting Angle according.That will increase the production efficiency.

8. Automatic roll changing system (optional):  The cylinder drive positioning gear to drive the active spline.Make sure the fast and accurate change of log roll but without stopping during cutting,
Save the loading and unloading time and increase the productivity.

9.Fast cutting shaft changing system (optional):   3 different size cutting shafts for optional.

You can cutting different size paper core log roll in the fast shaft changing device.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com