Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.
1. Introduction for Automatic adhesive tape cutting machine
1.1 Application: Bopp Tape, PVC Tape, Double Side Tape, Film and Paper
1.2 Working Width: 1.3m, 1.6m
1.3 Shafts Design: Single shaft, double shafts, four shafts etc.
1.4 Configuration: PLC control with Servo Motor
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc