Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.
Suitable for rewinding various tape such as BOPP tape, PE, PET, masking tape, double-sided tape, foam tape and paper, film etc many other adhesive and non-adhesive materials.
1) MITSUBISHI Servo motor and A.C. motor control
2) Programmable controller system, MITSUBISHI PLC control and LCD touch screen.
3) The tension is controlled by magnetic break.
4) Rewinding air shaft automatic air inflation system.
5) Automatic smoothing device to eliminate the wrinkle and air bubbles.
6) The pneumatic press roller is controlled by the cylinder and the products are properly pressed to ensure smooth during rewinding process.
The machine is suitable for slitting and rewinding various large roll materials,such as self-adhesive, paper,90goffset paper,PVC,plastic material,etc.
1. The machine adopts two Servo motor control, automatic tension, center reeling way;
2. This machine adopts frequency control, to maintain smooth operation during acceleration
3.Auto counter meter, auto machine stop when had alarm.
4.The rewinding adopts A,B inflatable shaft,operate neatly and assemble conveniently.
5.The unwinding adopts ultrasonic wave correcting method.
6.The circular cutter with slitting slitter edge and automatic discharge device.
7,Air shaft automatic pneumatic loading structure.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc