Electrical Slitter Machine

Electrical Slitter Machine

Tape Cutting Machine-

Second, preparation before use:
1. Check the external power supply is correct.
2. Check that the workpiece ground wire is clamped on the workpiece.
3. Turn on the air source and drain the water.
4. Check that the power switch is in the off position.
5. Close the main switch of the power supply of the power grid. At this time, the fan starts to work. Pay attention to check the wind direction. The wind should blow inward. Otherwise, the main transformer will not be ventilated and cooled, which will shorten the working time.
6. Turn the power switch on the panel to the “on” position and the power indicator light. Compressed air should flow out of the torch at this point. Pay attention to whether the pressure gauge pressure gauge pointer is 0.2-0.4 megabytes
Pa position, if the pressure does not match, in the case of gas flow, adjust the upper knob of the filter pressure reducing valve pressure gauge, clockwise to increase pressure, and vice versa.
7. Let the gas flow for a few minutes to remove the condensed water vapor from the torch.

Electrical Slitter Machine

Semi-automatic cutting machine technical operation rules
1. Scope of application
The semi-automatic cutting machine is a device for cutting medium and low carbon steel by flame using oxygen-acetylene (medium and low pressure) as a heat source. The machine can cut the straight line, the circle and the arc and the left and right 45 degree groove.
2. Qualification requirements for operators
2.1 The operator of the machine must be trained in safety professional skills.
2.2 The operator must understand how the machine is used and can handle faults that occur during operation.
3. Mechanical requirements for the working environment
3.1 This machine should not be used and stored in high humidity and high corrosion environment.
3.2 It is not advisable to carry out open-air operations in rainy and snowy weather and windy weather. If necessary, cover measures should be adopted.

Electrical Slitter Machine

Semi-automatic cutting machine technical operation rules

5. Control and monitoring methods for mechanical process parameters and characteristics
5.1 When installing the cross rail and main rail, pay attention to the adjustment screw should not be too tight or too loose. 5.2 The cutting tip should be installed so that it should not be tightened too tightly, no air leakage.
5.3 Before using the suction-type torch, the gas injection must be checked and pressed with the finger on the acetylene inlet valve head. Then open the oxygen valve and the acetylene valve. If there is suction on the finger, it means the torch is normal and can be used. If there is no suction, or oxygen flows back from the B-connector, the torch performance is abnormal and must be repaired.
6. Provisions for mechanical supervision and inspection
6.1 The cutting machine should pay attention to the good condition of each part in normal use, and solve the problem if it is found in time.
6.2 Strengthen maintenance and repairs should be carried out every year.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com