Second, preparation before use:
1. Check the external power supply is correct.
2. Check that the workpiece ground wire is clamped on the workpiece.
3. Turn on the air source and drain the water.
4. Check that the power switch is in the off position.
5. Close the main switch of the power supply of the power grid. At this time, the fan starts to work. Pay attention to check the wind direction. The wind should blow inward. Otherwise, the main transformer will not be ventilated and cooled, which will shorten the working time.
6. Turn the power switch on the panel to the “on” position and the power indicator light. Compressed air should flow out of the torch at this point. Pay attention to whether the pressure gauge pressure gauge pointer is 0.2-0.4 megabytes
Pa position, if the pressure does not match, in the case of gas flow, adjust the upper knob of the filter pressure reducing valve pressure gauge, clockwise to increase pressure, and vice versa.
7. Let the gas flow for a few minutes to remove the condensed water vapor from the torch.
Guolian Machinery -- GL-5000 Tape Cutting Machine
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.
Cutting length: 5 ~ 999 mm
Tape width: 6 ~ 50 mm
Maximum outer diameter: 300 mm
Speed: 200 mm/min
Weight: 2.8 kg
Size: 115mm X 140mm X 215mm
utomatic tape tape cutting machine ---
With the continuous development of industrial technology, traditional manual work such as cutting tape is now replaced by machines. Tape cutting machine is also called adhesive paper cutting machine and tape machine.
• The tape is automatically peeled off, cut according to the set length, and the cut tape is continuously and side by side attached to the edge of the rotating disk.
·The tape cutting length and the bonding interval can be adjusted at will according to the needs of the user.
·The cut surface of the tape is not jagged and very neat.
· The work of the production staff and the tape-cutting personnel can be completely replaced by one person, and it is more labor-saving and efficient.
·With a special tape cutter, it is possible to cut off the tape with a liner.
· Suitable for a variety of small adhesive tapes attached to the board.
· Unique conveyor system for multiple people to use at the same time.
· Small size, light weight and easy to carry.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc