Second, preparation before use:
1. Check the external power supply is correct.
2. Check that the workpiece ground wire is clamped on the workpiece.
3. Turn on the air source and drain the water.
4. Check that the power switch is in the off position.
5. Close the main switch of the power supply of the power grid. At this time, the fan starts to work. Pay attention to check the wind direction. The wind should blow inward. Otherwise, the main transformer will not be ventilated and cooled, which will shorten the working time.
6. Turn the power switch on the panel to the “on” position and the power indicator light. Compressed air should flow out of the torch at this point. Pay attention to whether the pressure gauge pressure gauge pointer is 0.2-0.4 megabytes
Pa position, if the pressure does not match, in the case of gas flow, adjust the upper knob of the filter pressure reducing valve pressure gauge, clockwise to increase pressure, and vice versa.
7. Let the gas flow for a few minutes to remove the condensed water vapor from the torch.
-------Suitable for cutting BOPP tape, PVC insulation tape, masking tape, double sided tape, duct tape, medical tape, etc.
1. Main driving part: Siemens AC motor with inverter is employed.
2. Operating panel: All functions are operated on the 10" LCD touch panel.
3: Motor control system: The central control system is PLC programmable controller.
4. Central control unit: Programmable central control is used and 20 sizes can be set on the same shaft for auto transfer and cutting.
5. Blade feeding positioning system: Blade feeding is controlled by Mitsubishi servo motor,and the cutting speed is adjustable in three stages.
6. Auto angle adjustment of circular blade: Mitsubishi servo motor is used to calculate the circular blade angle and the angle change is subject to different materials (the angle change range is ±8°).
7. Quick shaft change system: Three kinds of shafts are available and quick change of shafts is applied for different materials.
8. Cutting positioning system: Cutting positioning is controlled by Mitsubishi servo motor. The imported high precision ball screw is applied to set the size and the linear slide rail is to bear the load of the cutter seat.
-------Cutting pvc tape, bopp tape,PE, PET, EVA, masking tape , foam tape ,double sided tape etc .
1. Blade Feeding: straight blade feeding ,manually pushing the blade to cut the tape.
2. Use a hexagonal shaft for making the cutting size. This shaft is under the blade supporter. It has a fixed size on every side of this shaft. Different cutting size can be achieved by moving the shaft.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc