Second, preparation before use:
1. Check the external power supply is correct.
2. Check that the workpiece ground wire is clamped on the workpiece.
3. Turn on the air source and drain the water.
4. Check that the power switch is in the off position.
5. Close the main switch of the power supply of the power grid. At this time, the fan starts to work. Pay attention to check the wind direction. The wind should blow inward. Otherwise, the main transformer will not be ventilated and cooled, which will shorten the working time.
6. Turn the power switch on the panel to the “on” position and the power indicator light. Compressed air should flow out of the torch at this point. Pay attention to whether the pressure gauge pressure gauge pointer is 0.2-0.4 megabytes
Pa position, if the pressure does not match, in the case of gas flow, adjust the upper knob of the filter pressure reducing valve pressure gauge, clockwise to increase pressure, and vice versa.
7. Let the gas flow for a few minutes to remove the condensed water vapor from the torch.
1300mm jumbo roll width tape manual cutting rewinding machine:
1. Simple structure, convenient operation and maintenance.
2. The power of the whole machine is only 3KW, which saves energy, the motor and the spindle are driven by the triangle belt, and the machine has low running noise.
3. The cutting shaft adopts high quality carbon steel, which is tempered, high frequency quenching and chromium plating (unilateral 0.05 mm). The hardness reaches HRC60, wear-resisting and cutting.
4. The cutting knife is carefully processed by W18Cr4V, with sharp edge and high durability.
Automatic double sided adhesive tape cutting machine:
This machine is suitable for kinds of adhesive tapes or kinds non-viscous material high precision cutting.
Such as the protective film, high tempreture tape, 3M tape, optical film, foam tape, goldfinger tape, green tape and other electronic material.
You can cut different sizes according to different material.
4. Motor control system: The PLC programmable controller.You can set up various cutting size in the same log roll.Can be adjusted cutting size according to the set up cutting width and cutting roll quantity.
5. Cutting size positioning system: The Mitsubishi servo motor control.Make sure the high accuracy of the ball screw and the linear slide rail positioning in the cutting.
6. Feed positioning system: The Hydraulic motor / Mitsubishi servo motor to control the knife feeding.It can be anthropomorphized as a three-step feeding speed of the cutter.
Improve efficiency and get the best quality.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc