Third, pay attention to the operation process:
1. The torch is in contact with the workpiece and can be cut by pressing the button. Cutting can be started from the edge of the workpiece. When the thickness of the sheet is not large, it can be cut at any point of the workpiece. The torch can be perpendicular to the workpiece
Or slightly inclined to one side, but when opening in the middle of the workpiece, the torch should be tilted slightly to one side in order to blow off the molten metal and cut through the metal.
2. Press the handle button and keep the main circuit on, while the high frequency oscillator works until the cutting arc is formed, and the high frequency oscillator stops working. Thereafter, the cutting can be performed by the movement of the torch. At the same time, the cutting indicator lights.
3. The cutting must be cut through the metal to move evenly, otherwise the nozzle will be damaged. Moving too fast or too slow will affect the quality of the cut.
4, cutting air pressure adjustment: cutting air pressure is too high, the flow is too large, will affect the cutting thickness. If the cutting air pressure is too small, it will affect the service life of the nozzle.
5. Before lifting the torch away from the workpiece, the handle button must be turned on. At this time, the plasma arc is extinguished and the cutting process is stopped.
6. During the cutting process, the arc is re-arced because the torch leaves the workpiece more than 2 mm and the arc is extinguished.
7. When the main transformer temperature exceeds 110 °C due to the connection working time is too long, the thermal protection switch will operate and the device will automatically shut down and cannot be started. It should be restarted after the transformer has cooled down.
8. Always remove the accumulated water in the filter pressure reducing valve, that is, rotate the lowermost screw counterclockwise to remove the water and then tighten. If there is too much water in the compressed air, consider adding a filter valve between the filter pressure reducing valve and the gas source, otherwise the cutting quality will be affected.
9. When the workpiece is not cut, press the torch button as little as possible to avoid damage to the machine.
10. After the cutting workpiece is finished, cut off the power switch and the air supply valve.
The machine is suitable for slitting and rewinding various large roll materials,such as self-adhesive, paper,90goffset paper,PVC,plastic material,etc.
1. The machine adopts two Servo motor control, automatic tension, center reeling way;
2. This machine adopts frequency control, to maintain smooth operation during acceleration
3.Auto counter meter, auto machine stop when had alarm.
4.The rewinding adopts A,B inflatable shaft,operate neatly and assemble conveniently.
5.The unwinding adopts ultrasonic wave correcting method.
6.The circular cutter with slitting slitter edge and automatic discharge device.
7,Air shaft automatic pneumatic loading structure.
This unit is suitable for cutting various materials such as PVC,OPP,PE,Masking tape,Double-dide tape,Kraft tape,cloth tape etc.
1:Main driving parts:Ac motor with inverter is employed and the acceleration and deceleration are fast and stable
2:Central control unit:programmable central control is used and various sizes can be set on the same shaft by antomatic transfer and cutting .
3:Operating panel:all functions are operated on the LCD touch panel
4:Auto adjusting the circular blade angle:the serco motor is subject to different materials
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc