Tape Cutting Machine- working principle
The tape cutting machine is also called a tape cutter. The tape is cut by the upper and lower blades, and the length is set according to the length of the customer's demand.
The tape cutter has a sensor, and after the tape cutter cuts the tape,The tape will fall over the sensor. If the tape is removed, the sensor will automatically sense that there is
no tape and immediately send a signal, and the tape will automatically perform the next cutting action. This kind of action is repeated continuously, that is, automatic continuous cutting.
Yuanxiao tape cutting machine mainly has automatic tape cutting machine and manual tape cutting machine. Now it has a wide range of automatic application. Manual cutter is mainly used for tape sealing.
Automatic tape cutters are used in the electronics industry, wire harness industry.
Semi-automatic cutting machine technical operation rules
5. Control and monitoring methods for mechanical process parameters and characteristics
5.1 When installing the cross rail and main rail, pay attention to the adjustment screw should not be too tight or too loose. 5.2 The cutting tip should be installed so that it should not be tightened too tightly, no air leakage.
5.3 Before using the suction-type torch, the gas injection must be checked and pressed with the finger on the acetylene inlet valve head. Then open the oxygen valve and the acetylene valve. If there is suction on the finger, it means the torch is normal and can be used. If there is no suction, or oxygen flows back from the B-connector, the torch performance is abnormal and must be repaired.
6. Provisions for mechanical supervision and inspection
6.1 The cutting machine should pay attention to the good condition of each part in normal use, and solve the problem if it is found in time.
6.2 Strengthen maintenance and repairs should be carried out every year.
Guolian Machinery -- GL-5000 Tape Cutting Machine
The operation method of GL-5000 is different from that of disc tape cutter, because they are different types of tape cutters, and the shape is also very different. This tape cutter is ready to cut, if cut. If the tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter GL-5000 has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc