Tape Machine Outputs
Specialized in coating PET film.
Suitable for coating of BOPP adhesive tape.
Introduction of four-axis winding new tape machine -- GL- X multi-function tape machine
Tape machine parameters settings:
Temperature: Drying temperature During heating and drying, the BOPP film can be set to a drying temperature of 60-70 ° C. In natural drying, a fan can be used to accelerate the air circulation on the surface of the printing material to increase the drying speed. Tension: The machine generally has four stages of tension control, namely unwinding tension, feed tension, traction tension, and winding tension. The more stable the tension, the more stable the generation operation and the more assured the quality. However, the tension in each zone during the production process is mainly based on the individual experience of the operator in the production process; the material which is not very good in straightness can increase the tension appropriately.
Tape Machine Outputs
Tape factory budget cost --
Production process
crafting process
Printing
Printing patterns and text on the sealing tape not only increases the value of the tape, but also gives the tape a certain advertising function. When printing, it is necessary to pay attention to selecting the appropriate ink. Improper ink will affect the coating effect of the pressure sensitive adhesive. Something will lead to the adhesion of the pressure sensitive adhesive at the pattern, and the rubber transfer phenomenon occurs during unwinding.
2. Coating and drying
Coating is the most important process for making sealing tape. The pressure sensitive adhesive is applied to the BOPP film and then dried by an oven.
3. Slitting and winding
Cut the parent roll into the size that the user needs, and then curl it. This process should pay attention to keep the sharpness of the slitting knife, otherwise the edge of the tape will be uneven, which will cause the tape to be easily torn when it is wound.
Plant area
According to the size of the tape machine, it is 9.6 meters long, 2.2 meters wide and 2.2 meters high. The required workshop area is 25 × 10 = 250 square meters. The office area needs 10×10=100 square meters, and the total plant area is 250+100=350 square meters.